Wheel studs replacement

Question edited for clarity.

Question moved to model category.

Changing a Right Rear Stud

Jeep Liberty Forum https://www.jeepkj.com > ... > KJ General Discussion
Mar 24, 2008 - Put the new stud in the empty hole as far as you can by hand. Then take your new nut, thread it on to the new stud BUT REVERSE THE NUT. YOU WANT ...
How do I replace a wheel stud ' Jeep KJ and KK Liberty Forum
Apr 14, 2019
wheel stud/ lug nut disaster. - Jeep Liberty Forum
May 16, 2010
How do I replace a wheel lug? ' Jeep KJ and KK Liberty Forum
Jul 28, 2009
Wheel studs from hell. ' Jeep KJ and KK Liberty Forum
Jul 17, 2011
More results from www.jeepkj.com

How to Replace a Broken Wheel Stud (DIY)

The Family Handyman https://www.familyhandyman.com > Automotive
Jan 3, 2023 - Center the driving screw over the stud and tighten it with a ratchet until the stud pops out the back.

strip it down to your hub the hub holds the studs .it is a push pull fit .but an old nut on it.then hit the top of it .it when then push in.remove the nut. push in the new stud from the rear of the hub.put a larger nut on top of stud ,then your wheel nut to pull the stud into the hub.then remove the wheel nut .then refit the parts taken off.and fit your wheel.

if memory serves,you should be able to replace wheel stud by hammering it out backwards/inboard.then replacement is a case of pulling new stud through.

very easy remove wheel support car on jack stands take hammer and beat the old stud out put new stud in place thick metal washers on stud titen lug nut on stud until stud is all they way in place replace wheel and ur all done

Yeah , it's a fairly simple repair, All the wheel studs must be replaced and lug nuts also.Closely examine the wheel or get competent tyre replacement company to double check for damage ! Remove the brake disc caliper and brake disc itself (usually 2 cross head screws) , tap off (gently) it may be stuck thru corrosion / rust etc , Broken studs can be knocked out(towards drive shaft ) of the hub assy with a suitable drift and hammer (splined into hub) . The studs are a servicable replacement part. Check all other wheel nuts as this is usually a result from poor fixing or wheel replacement recently .. Good luck

Should be a pressed in wheel stud, remove hub and have old one pressed out or you can do it the primitive way, by double nutting the old stud and striking it with a hammer to pound it out, if threads are bad then just strike the stud by itself , then replace new stud in opposite fashion...

The studs press out and in. Perhaps a hammer would work. Replacements studs can be purchased. Need to remove hub, of course.

Studs are pressed in. Heat the studs with a propane torch, and then use a ballpein hammer to pound them out. Insert new studs, and use nuts to draw them into place

Yes you can replace the broken wheel stud. The wheel studs are pressed into place, and a vise will work to press it out, and in. You will have to remove the wheel hub, and then use a deep well socket and a bolt or something smaller than the actual stud to remove it with a vise. To replace it, you will need to use the deep well socket on the thread side of the stud, and press the new one in with the vise.

I hope this helps you, and I wish you luck with your repair.

Wheel studs are replaceable.See your local dealer.