P1000 code what is the equivalent of codes P1000(52).(62).(65).(75)

P1000 Jaguar Code - On Board Diagnostic System Readiness Test Not Complete link to info
copy and paste

https://www.engine-codes.com/p1000_jaguar.html

P1000 is a manufacturer specific fault code:

Ford P1000: OBDII Monitor Testing Not Complete.
Jaguar P1000: Engine control module (ECM) - internal error.
Kia P1000: System diagnosis incomplete.
Land Rover P1000: Engine control module (ECM) memory erased - no codes stored.
Mazda P1000: OBDII Drive Cycle Malfunction.

So depending on the manufacturer of your car would depend on the meaning of a P1000 code!

Hi, now it depends, I take you have a code reader? if so you should have a code reset? If the car is as you said, remove and clean injectors, I know its a pain, but as the car is not running this is the only way to clean them.
I hope this helps. What code reader are you using to know its code: P1000

OBD system tests
Possible fault codes:
P1000 OBD system tests Operation not
completed
Setting of the fault code P1000 has no
influence on the system <Engine
management>, smooth running or performance
as long as it is automatically erased
whilst driving.
The fault code P1000 indicates noncompletion
of system tests.
* Misfire detection
* Evaporative emission control system
* Exhaust-gas recirculation
* Lambda sensor
* Exhaust gas catalytic converter
The fault code P1000 cannot be erased. It
is cancelled automatically once the
vehicle has completed certain driving
cycles.

P1000 is a "PASS" code, test complete no problem found.

what does it mean p1000 code

Hello, my name is Ben. Here is the short answer: P1000 OBD-II Monitor Testing Incomplete
P1000 will be set anytime there is any interruption of power to the PCM. This action could be but is not limited to, changing the battery, clearing history codes, or reprogramming the PCM. If there are no other codes stored the P1000 will clear itself after several "driving cycles". I hope this helps you, Ben.

P1645 EVAP Solenoid Output Circuit
P1000 Scan not complete. meaning it didnt finish scanning

P1000 means that you or someone has disconnected the battery,and the car has not been driven far / long enough for the computer to relearn its stratagies.
Engine light could be the fault of the speed sensor, or wiring to the sensor.

a p1000 code means that the system has not run all checks since last memory erase. in other words after a code erase this code is set until the car has been driven for 2 drive cycles which is 20 to 25 miles then 20 to 25 miles again.