Do you know how to do automotive electrical testing ? How to use a DVOM - digital volt ohm meter ? You have high resistance in the circuit . Use voltage drop to find the problem .
Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia
SOURCE: Turn signal left front won't flah
I dealt with a similar problem on an 01 Alero (very similar car) and found that the wire that grounds the signal filament of the bulb was broken inside the harness. I tapped into it and grounded it to the chassis and resolved the problem. It's no guarantee but if you have a multimeter, check each wire's continuity to ground as well as the impedance between each of the wires on the harness, on both front signals (for comparison purposes), and it'll show you if you have a problem such as the one I dealt with.
SOURCE: 1998 Buick Century Signal Issue
foun mine on the driver side between the drivers door and the dash if you but the trun signal on you should hear it cleak clak
SOURCE: I have a 1998 Buick
I had this same problem it was the turn signal socket go to a junkyard and plug it in with a brand new bulb
448 views
Usually answered in minutes!
×