Replaced the fuse about a week ago and it worked fine, now everytime I put a new fuse in ignition sw1 it blows. AS soon as the key is turn slightly it blows the fuse car cranks but no ignition..Thansk Leo
Im having the same issue on my 2002 toyota camry le 2.4 the am1 fuse keeps blowing but only after the car is warmed up turned off and turned back on without waiting for the car to cool down for a few hours any clue as to why
You have a short in that circuit chck your harness for wiring that might be exposed to ground or pinched
SOURCE: the fuel injector fuses keeps
There is a short circuit to ground on one of the circuits that the fuse protects. I need more information about your car and exactly which fuse is blowing. (Year, Make, Model, Engine size) All of the circuits powered by that fuse must be traced to find exactly what is causing it to blow. Most of the components can be eliminated as the cause by unplugging them one at a time and checking the fuse connector with a test light. (Otherwise, you could go through a lot of fuses trying to figure it out.)
SOURCE: fuse for the dash keeps blowing on 2001 kia
SOUND LIKE YOU HAVE FAULT IN THE TCM OR PCM.THE TRANSMISSION SHIFT SOLENOID FAULTY. YOU NEED A GARAGE OR TRANSMISSION SHOP TO USE DIAGNOSTIC EQUIPMENT TO LOOK FOR TRANSMISSION FAULT CODE SINCE TRANSMISSION IS TCM AND PCM CONTROLLED.
2,355 views
Usually answered in minutes!
I removed the fuse block and no wires were exposed back to the firewall where they enter the inside. I did a bipass on the fuse with a jumper so I could move the van in te garage, I then placed another fuse in the slot and it started working again. is it possible. bad relay in te same box for ignition?
×