Crank position sensor cherokee 2.5td - 2000 Jeep Cherokee

SOURCE: crank position sensor

need to know what engine but on six cylinder it is on the bell housing at the left rear of engine,on 5.2/5.9 it is on the right side behind the head in the block,and on 4.7l it is on the engine block above the starter.

SOURCE: locate crankshaft position/crank angle sensor

The crank posistion sensor is located on the top of the transmission bell housing right next to the motor, its a @$^&^ to get to and do without a lift,

ZJ Limited

• 17989 Answers
• Posted on Jul 10, 2009

SOURCE: how to replace jeep cherokee XJ 2,5td headlight

Check this info:
- Jeep-XJ-2000-08l-Lamps
- Jeep-XJ-2000-08la-Lamps

Good luck!!!!

SOURCE: how do i replace the crank position sensor on a

If you have the type of crank angle sensor shown in the image, then it will be located on the bell-housing towards the top of the bell-housing and usually on the drivers side. Dis-connect the faulty crank angle sensor and then un-bolt the two bolts that secure the crank angle sensor to the bell-housing and then remove the sensor. The best access to the crank angle sensor is from under the vehicle.

SOURCE: Please Tell me Where Is

The crank sensor is on the upper left side of the transmission bellhousing.