Meter wiring breakage
This site will give you the factory service manual for your frontier. You will need to choose the specifics for your truck.
Nissan Frontier Factory Service Manuals
SOURCE: Nissan 2008 Frontier Crew Cab speaker wiring.
1. Check your receiver first, and if you can see the wires in the back,
2. Test your speakers, you can use 9v battery and find out which wire for which speaker, connect them one by one.
3. If you have floating ground receiver, ( each speaker wire from the receiver has + and – wires)please be careful, you have to connect them positive to positive and negative to negative, do not let wire touch the ground, otherwise burn out your unit, but if it is a common ground unit, you can connect the + positive side of the speaker and connect all –negative wires together.
Hope this can help
SOURCE: I am adding trailer lights to my 1998 nissan frontier
You may be better off checking at dealer, or autoparts store for an adapter harness that goes inline. They simply plug into the harness ahead of all your tailights etc, and make it easier. At most, you may end up having to run a separate wire for brake control.
SOURCE: replace seat belt on 2000 nissan frontier
Should be a T50 or T55. Should have a cover over the bolt. Remove the cover, and remove the bolt.
SOURCE: 2006 Nissan frontier 4 cylinder belt diagram + tensioner pulley
They are under the hood or on the front crossmember.
Regards,
matt
SOURCE: change brake light bulb on a 2000 Nissan Frontier
The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.
379 views
Usually answered in minutes!
×