2007 Chevrolet Colorado (Extended Cab) New Cars Logo

Related Topics:

A
Anonymous Posted on Apr 10, 2014

My 2007 Colorado won't shift down pass reverse, could it be the shifter cable?

Runs great but won't shift to the right of reverse on the shifter

5 Related Answers

Anonymous

  • 16 Answers
  • Posted on Dec 14, 2008

SOURCE: wont shift out of reverse,but the shifter moves up and down freel

your linkage on the transmission must be off. try having someone move the shifter while you watch the linkage arms under the car on the trans to make sure its all intact. it could be a loose or broken bolt on the trans causing it to not disengage from reverse this will cause it to not start.

Ad
johnjohn2

Johnny Brown

  • 5763 Answers
  • Posted on Oct 19, 2010

SOURCE: This morning I shifted my

You will need to look at the top of the trany and see if the linkage is moving or if the cable is moving to determine the problem, look under the dash while moving the shifter to see if the bracket under the dash thats bolted to column come loose, if it did not then look at trany to see if the linkage came apart at trany.

Anonymous

  • 2 Answers
  • Posted on Dec 27, 2011

SOURCE: 1999 Silverado shows in park but will not shift into other gears. Shifter goes down

cable goes down steering colmn under carpet under drivers seat thru floorboard

fordexpert

  • 5692 Answers
  • Posted on Nov 16, 2012

SOURCE: 2003 Chevrolet Cavalier automatic won't shift to park and reverse its stuck on neutral and drive

I think it is linked to the Starter Interlock system and probably a switch on the Brake pedal lever under the dash.

There is suppose to be a safety system(check brake lights) which prevents starting the car without a foot on the Brake or without the car in Park.

Some makers may allow starting in Neutral like the old days; but the intention of the system was to prevent runaway cars from moving when the Gearshift lied about being in Park.

I know that the system had to be adjusted "referred to as timed" so that the shift linkage, Brake pedal switch and sometimes Ignition switch had to be in the right place for everything to work.

Reading your problem it is evident that part of the system was crippled for some time, and finally fell apart on you.

Possibly your shifter indicates D when it is in another gear and that the linkage is binding and preventing the correct selection of gears.

You could securely jack a rear wheel off the ground and disconnect the trans linkage. Have an assistant operate the gearshift and see if it makes sense and if it is binding. If the shifter seems okay, your only choice is to try to operate the shift lever sticking out of the trans. Engine OFF. To see if valve body in trans is rough.

Alternative is to tow it to a Repair shop for diagnosis. Notice I did not say Trans shop. You don't know if you need a Trans shop yet. So taking it somewhere where they do not install Transmissions will go further in getting only what is necessary fixed.

Please rate my info, I hope it helps.

Anonymous

  • 33 Answers
  • Posted on Apr 01, 2013

SOURCE: Car won't shift into reverse...Shifter moves but that's it..

im assuming this is an automatic transmission? it sounds like the cable or the linkage to the transmission gave out. your gonna have to get under the hood or under the car to see. it may be a easy fix-good luck!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2007 hhr wont shift

You may have a shifting cable that is coming apart. Disconnect the cable from the transmission and see if the shifter moves freely. If it does, replace the cable.
0helpful
1answer

I have a 1987 Mazda B2000 pick up. My shifter will not fit back on my newly re-built transmission. Do any other shifters work with this model as I am unable to locate an original for replacement.

I'm sure you have checked the shifter and shifter spring,,...Shifters can be rebuilt also....Make sure your clutch linkage is properly adjusted...The clutch is non adjustable...They may have got air in the hydraulic lines while removing and installing...This would give you a spongy pedal ...Most shifters in order to put it in reverse you push over and up or over and down......if shifter is loose and wobbly it won't have enough force to push the reverse shift rod....However if shifter is in great shape it sounds like the reverse shift rod could be hanging up and not sliding the shift fork...It could be the rebuilders fault......Reverse gear is the largest gear in the transmission and it is located at the back of TRANS which means it will require more force to put in reverse.......I would take it back to rebuilders shop and tell them something isn't right with going to reverse gear...if you wait too long they will think it is something you may have done by incorrect shifting.....
0helpful
1answer

Why my 2007 crown Vic won't shift in gear

this can be due to out of adjutment of shifter cable which releases the shifter when brake is pressed.
0helpful
1answer

Shopping in the Mall the trasmission dont change. I select drive, reverse , L1 but nothing pass. Well i call the towing service. Its possible the problem is a relay or damage cable? The model is...

the shifter cable may have worked loose or broken. do you feel the same resistance that you used to when shifting? or just a very loose floppy shifter,if so,i suggest a broken or loose shifter cable.thank you for choosing fixya.com and by the way no relay will keep your shifter from shifting gears from park to drive,reverse.
3helpful
1answer

1999 Saturn sl with shifting problems first gear and reverse

Ms Derry ,I would check the pair of shift cables and shifter itself before suspecting internal transmission problems.The cables attach to the shifter then runs to the linkage on the transmission.One cable is responsible for side to side movement as the other is for moving front to back(like 1st to second) Center console removal is fairly simple which requires mounting screw(4) removal on the front sides and in the rear cup holder.This gives you an opportunity to view the shifter and cable operation from above while this movement should also be appreciated at the transmission linkage meaning someone shifts the vehicle as another inspects proper movement at the transmission.If all this is actuating properly,you may need to tear down and inspect transmission but hopefully it can be rectified with external repairs mentioned...good luck
1helpful
1answer

2007 dodge caravan, won't start at first. I leave it and fiddle with the gear shift and finally it starts. Runs no problem, shut it off and it restarts. Noticed that the gear shift light shows reverse when...

Sounds like the shifter linkage needs adjusted. There is a neutral saftey switch that prevents the car from being started in any foward or reverse gear. If the shifter linkage is out of adjustment, the neutral safety switch will give you starting problems.
1helpful
1answer

1994 chev lumina, trans problems

If there is a delay(like 2-3 secs) when you shift from neutral to drive...then down to reverse...most likely the transmission is screwed,or on its way out.
Is the Fluid level correct?,and is the fluid red or dark and smelly ?.

Dark and smelly IS NOT A GOOD SIGN.--means the fluid has been overheating ...


0helpful
1answer

2007 GMC Sierra 2WD 4.3 litre shifter problems (automatic)

More then likely the cable from the shift lock solenoid that unlocks the shifter is binding up or the shift lock solenoid is sticking..
1helpful
1answer

1990 Toyota 4runner wont go into 5th or reverse

They had a problem with this plastic washer that is in the shifter tower it sits just under the shifter it self and gets worn out and causes this to happen- hope that helps.
Not finding what you are looking for?

89 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...