2000 Hyundai Sonata Logo
Posted on Jun 17, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Hyundai sonata 01 jerking slow take off high idling

Problem codes po715 and po765

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 776 Answers
  • Posted on Jun 25, 2009
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: May 26, 2009
Answers
776
Questions
0
Helped
526580
Points
1939

P0715 = Input Shaft Speed Sensor Malfunction
P0765 = P0765 Overdrive solenoid valve problem
The Input shaft speed sensor is located on top of the trans (center) under the shifter cable (the shifter cable is connected to the transaxel range switch). The Overdrive Solenoid valve is located INSIDE the trans (oil pan must be removed to access it).Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Throttle body

Did you change the Idle air motor as well? It is sometimes possible to clean these.
0helpful
1answer
1helpful
1answer

I have a 2000 Hyundai Sonata that runs rough when you start it up. I hooked a code reader to it and it said that system was lean on bank 1 and multi misfire and not reading 02 sensor on bank one. I have...

time to get the engine properly scanned, real time not code scanner, then you will have the readings from sensore and actuators, diagnose from there
1helpful
1answer

I've been having problems with my Hyundai Sonata 1999 with a 2.4L 4 cyl. Running rough when started. Have to push gas pedal to start or stalls after running for a few seconds.. Sluggish/jerky starts when...

could be a few things the start up could be the idle air control sensor (my first thought), the coolant temp sensor for the computer might be a secondary thought for the engine being cold if the computer thinks its warm. that would be the first 2 places i would start without a check engine light or code to reference
1helpful
1answer

2006 Hyundai Sonata: Wet road causes power steering failure

Ok, the high pitch sound is your idle pulley bearings going bad. The splash of water is exactly that, the belt gets wet and slips. Definitely a pully, more than likely the idler pully.
0helpful
1answer

2000 hyundai sonata.. P0300, P0110 and P0102 codes..

Higher octane gas 93 with some good octane boost in the black can at autozone cost about 7 dollars or a bottle of 104 octane boost. Change the fuel filter. Probably only one coil pack is bad. The OBDII reader should tell you which one was a misfire.
0helpful
2answers

Hyundai Sonata 2002 idle at high RPM and accelerate 40-45 MPH

Look for a vacuum leak somewhere. This is the most common problem for a high idle.
8helpful
2answers

2000 Hyundai Sonata jerking and causing poor performance

The turbine shaft speed sensor can cause this problem, It is also know as the transmission input shaft speed sensor. It will cause the transmission to **** and also stick in 3rd gear, which wound cause slow acceleration.
8helpful
1answer

Code p0335, and jerkinging problem with pending codes p02300 and p0711

THE INTERMITTENT SIGNAL FROM THE DEFECTIVE CRANK SENSOR IS CAUSING THE CAR TO STARVE OF SPARK AND FUEL. IF YOU REPLACE THE CRANK SENSOR, THIS WILL FIX THE JERKING PROBLEM BY HAVING A CONTINUOUS FLOW OF FUEL AND SPARK. THE TRANSMISSIONS ON THESE CARS ARE NOTORIOUS FOR SHIFTING PROBLEMS. THE TRANSMISSION MAY NEED A NEW FILTER AND FLUID. HOPE THIS HELPS. KEEP ME POSTED PLEASE. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK
Not finding what you are looking for?

1,188 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...