Front axles My 2003 santa fe is making clicking noise when driving and now four wheel drive warning lights are staying on when engine is running a mechanic told me I have to change computer system and the work would be more then the cars is worth I read somewhere that there is chip that will reset when I change the axles is this ture

SOURCE: warning light on my car's dash board

hi, this warning light is either telling you the water level is low or the temp is to high.
If this light comes on as soon as the ignition is switched on then its more than likely low water level or it could be that the sensor itself as give up working, these are not that expensive to buy but check your water level first and top up if needed.
If the light comes on after you have been driving for a while then this is telling you it is getting to hot which usually means the thermostat needs replacing.
Any of these problem shouldnt cost to much to repair as their are plenty of parts available so will be cheap and easy to get.

Hope this is some help to you if you have any problems or questions then give me a shout back.

As for driving 300 miles then if the light comes on as soon as you start the car then you should be ok but if it comes on after the car has been driven then it could over heat and this can cause the head gasket to blow and then this mean very expensive repair. So if this is the case then when the light comes on its best you switch of and rest for 30min to get the temperature down. If the lights on as soon as you start the car then you should find you will be ok.

anwar alkhaldi

• 197 Answers
• Posted on Mar 17, 2009

SOURCE: Chirping in steering wheel of 2007 Hyundai Santa Fe

bad p/s belt or need tide

SOURCE: 2003 Hyundai Santa Fe ABS light is on along with TCS light

you may have damaged the ABS sensor or wire to the sensor up front check the wire that runs from the inner finder well and make sure it connected to the ABS sensor on the spindle

SOURCE: need to replace Drive Belt Pulley for 2003 Hyundai

your senario revolves aroud the milage on your vehicle.should it be a high milage we can call it common.if you did replace the belts then the next step will be is to see hou deep the belt inbeds in to the pulleys.if to deep then it will slip and make a noise

SOURCE: 2002 hyundai santa fe - engine noise ticking

The cam chains have developed slack and are slapping on the cam chain guides which helps prevent the cam chains from popping off in case of slack developing . The chain guides are made of some type of plastic material and develop significant wear.