1997 ford tarus shift indicator

Your car has went into a fail safe mode, either one because the speedo is not the proper gear ratio for that particular vehicle, not all of them were the same, it depends on the exact model. For instance, a Tarus SE is different from a Tarus LE / SE / on and on, and if the gear ration is not correct, then the TCM will not ssend a signal to the shift solenoids to do their job thus the car wont shift. It sounds to me like your original issue may have been that the speedometer didn't function or work at the cluster, ad you've made repairs to the wrong part. Change your Spped Sensor, and it will be ok, IF the cluster is for that particular vehicle. If it is the proper part, your only issue is the speed sensor.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/samuel_4e847b1ae10ff587

You can check if the botton is the right ,or maybe then doesn't connected we ll.

A 1997 Jeep Cherokee has 190-hp and 225 ft/lbs of torque at 3,000 rpm. ---------------------------------------------------------------------------------------
Tacho Pro 2008 July PLUS

You need to check the fluid and refill to proper level if low. And, if the fluid looks burnt (anything but a clear pink) it and the filter need to be changed. If that doesn't help take to a transmission shop to have it scanned because it could be a faulty or bad sensor.

Green coolant 50/50 mix.

What is your question? .....so for we just have your statement about a leak!

then the transmission has failed or has sticking engagement solenoid in trans pan, have the fluid and filter replaced and see if that corrects the problem

GO TO AUTO-ZONE OR KRAGEN AUTO AND HAVE THE COMPUTER TESTED FOR THE TROUBLE CODE THAT THE CHECK ENGINE LIGHT SET IN MEMORY. THIS TEST IS DONE FREE OF CHARGE, POST THE CODE BACK HERE, MOST LIKELY IT WILL BE A TRANSMISSION SHIFT SOLENOID CODE.

This is usually caused by the switches sticking in the door latches. Try spraying some WD40 in the latches and open and close the doors a bunch of times that should take care of it.

Sounds like the amplifier has died. Best bet is to try to replace with a used one. Repairs are expensive.