My 92 toyota privia is not keeping antifreeze nor water in radiator.seems to come out thru exaust pipes.smokes white.help plz.thanks
The gasket between the engine block and top is blown. Its probably cheaper to buy a new car than fixing this. Just
SOURCE: fusebox
Look at the center of the dash, above the radio, where there is a "hump". That is the door to the fuse box. There should be a latch, above the radio/heater controls, under this door... Depress it & it lifts up towards the windscreen.
SOURCE: 1992 Toyota Previa van,Oil dripping onto exhaust manifold, replace head gasket? need a free manual!
The toyota previa uses a formed silicone gasket for the valve cover and the cover is held in place by metric shoulder bolts ( 10mm). The valve gasket leaks because you can't get enough preload on the bolts to re-seat the old gasket when it gets old and shrinks. The shoulder bolts only allow you to tighten the gasket enough to seat the shoulder on the bolt. If you continue to torque down the suspected bolts, you will snap the bolt off ( don't ask me how I know this ). You can either 1.)replace the old gasket with a new one or 2.) remove the existing bolts around the leak area and put in new metric bolts that do not have a shoulder. You may want to put in a small sleeve into the existing bolt hole but shorter than the thickness of the valve cover to account for the smaller diameter bolt. You can now torque down the bolt and get enough preload to seal the valve cover without removing the old gasket. Make sure you use a torque wrench ( in-lbs) or be very careful not to snap these small valve cover bolts.
SOURCE: 92 Toyota Camry, antifreeze leaking no leak found
have you had the undercarriage inspected for white stains from coolant, rust stains if your system is corroded? How many miles? has the water pump ever been replaced, that would be my guess, water pumps leak while the eng is running and the hot engine evaporates the coolant, so in many cases none on the ground. Also have the system pressure tested by a shop and put on a rack to check for signs of leaking under the car.
Testimonial: "Thank you for your answer. I have not changed the water pump since I bought the car 5 yrs ago. I will check that."
SOURCE: 1993 Toyota Camry V6: Coolant Overheating Problem.
how do u change the water pump in a 1993 toyota camry v6 engine?
SOURCE: i have a 19991 toyota previa. the oil level light
If the light is flashing there could be problems with the electrical wiring. The easy places to check are at the bottom of the oil reservoir (pass. side under the hood) and at the driver side of the oil pan under the vehicle where the wires plug into the sensor. If this doesn't resolve the problem then it isn't easy, and testing the circuit will have to be done by someone who knows their electrical "stuff." Even the pump motor for the reservoir could be out.
If the Oil Level Sensor light stays on and you have already checked to make sure the oil level read on the dipstick under the driver side seat engine compartment is reading adequate, then you have a sticking oil level sensor float. Replacing the oil level sensor is easy, but extremely expensive ($485 in 2012). You can try to clean the plastic spool that the float slides on, but the problem is usually that it has swollen or expanded (likely from heat in the oil). One could try to sand it down but this would be difficult. I have made a new part out of nylon 6/6 on my lathe and replaced the plastic spool so far with excellent results. I'm considering selling it as an aftermarket part when I see if mine works. It would be a lot less than $485 dollars from Toyota. Or possibly have people send it to me and I'll repair the sensor myself.
309 views
Usually answered in minutes!
×