My alarm went off. I started the jeep but it died. now it wont stay running. my remote will not work. how can I fix this
SOURCE: How can I reset my Factory Alarm on my Jeep it wont run
Alarm Module Reset Procedure
NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.
When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.
The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.
Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the lift gate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.
Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.
Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.
SOURCE: 1996 jeep grand cherokee limited won't start alarm keep flashing
try the 15 amp fuse under the hood by the battery if its blown put in a 20.
turn on the key and wait for all the ligth to go out then try it if it dosnt start the first time do it a 2nd same thing
hope it helps
SOURCE: lost alarm remote and jeep wont start
Is this a factory alarm, or after market? If its a factory alarm you can disarm the sytem using the key, insert into the door and turn the key so the door unlocks, this will disable the alarm.
If it's an aftermarket installed by a stereo shop, there should be a valet switch under the dash or somewhere, put the key in the ignition, turn forward and flip the dip switch in the other direction. If not, then you will need to go under the dash, find the alarm box and pull the plug out.
Check and clean Idle air control valve. Make sure its responding to signal as well. Also make sure ther are no vacuum hoses disconnected. This may not be a "cure" but it's a good place to start.
SOURCE: 91 Jeep wrangler New everything idles rough, no Power then dies
you check for miss how is compression
127 views
Usually answered in minutes!
×