Chevy venture runs rough backfires, but does not do it all the time.
SOURCE: Thermostat in a 2003 chevy venture van
no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.
SOURCE: Help changing thermostat 2002 chevy venture
THERMOSTAT REPLACEMENT
Removal Procedure
1.Remove the air cleaner and duct assembly.
2.Drain the coolant until the coolant level is below the thermostat. Refer to Draining and Filling Cooling System .
3.Remove the crossover exhaust pipe.
4.Remove the radiator hose from the thermostat housing
5.Remove the thermostat housing bolts and clean any sealer from the bolt threads.
6.Remove the thermostat housing and gasket.
7.Remove the thermostat.
8.Clean the mating surfaces.
Installation Procedure
1.Install the thermostat.
2.Install the thermostat housing and gasket.
3.Install RTV sealer, GM P/N 1052366 or the equivalent, to the thermostat housing bolt threads. .
4.Install he thermostat housing bolts.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
5.Install the radiator hose to the thermostat housing.
6.Install the crossover exhaust pipe
7.Install the air cleaner and duct assembly.
8.Fill the cooling system. Refer to Draining and Filling Cooling System .
9.Inspect the cooling system for leaks. Repair as necessary.
http://www.2carpros.com/forum/automotive_pictures/99387_Graphic2_59.jpg
http://www.2carpros.com/forum/automotive_pictures/99387_Graphic3_26.jpg
http://www.2carpros.com/forum/automotive_pictures/99387_Graphic4_13.jpg
SOURCE: jump start 2000 venture
In order to reach the negative terminal to the battery in a 2000 Vebture (I have one) you must first remove the fuse housing. The fuse housing is a large black box that sits atop the battery. There os a single bolt that holds it in place located in fron of the battery bolted into the lip of the motor bay. Unscrew this, then unhook the fuse housing from the cross bar running from the back roght to the front of the motor bay. This is a tight fit so watch your knuckles. Once the fuse housing is out, the negative terminal is located on the backside of the battery. It is a tight squeeze black is negative, red is positive.
SOURCE: how do you reset power sliding door on 2000 chevy venture
there should be information in your owner manual telling you how to do it if you have miss place your owner manual try this website to see if you can down load one for your car its www.edmunds.com and i hope i was able to help you Michigan Man
SOURCE: fault code p0440 CHevy venture
I had that exact code a couple weeks ago. Mine needed new oxygen sensors. They(there are 2, only one was throwing a code, but I had both replaced) cost a little over $100 to have replaced.
285 views
Usually answered in minutes!
×