SOURCE: 02 Mitsubishi Eclipse heater gets hot only when in motion
Does your engine temperature guage read normal? Have you checked your coolant level? This can be the result of a partially seized thermostat... there is also a valve in the heater core lines that can seize partially closed. As the engine speed increases, the water pump can force more water through the partially closed component.
SOURCE: car idles high after its warmed up
you have to check on the fast idle control valve or pcv if it needs cleaning or replacement. Also check on vacuum leaks.
SOURCE: Mitsubishi Eclipse Ac and heater problem
cold air on passenger side of car and warm on drivers, why
SOURCE: Stalls when at idle after changing battery
When you changed the battery the computer must re-learn the setting again. If it continues have a OBD II reader plugged in and check for codes.
SOURCE: 02 mitsubishi eclipse p507 code.
P0507 - Idle Air Control (IAC) System RPM Higher Than Expected
This P0507 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0507 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM. In the case of GM vehicles (and possibly others) if the idle speed is over 200 rpm higher than expected, this code will be set.
Potential Symptoms: Most likely you'll notice the idle speed is higher than normal. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.
Causes: A P0507 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* Leaking air intake after the throttle body
* EGR valve leaking vacuum
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Failed EVAP system
* Failed IAC (idle air controller) or faulty IAC circuit
Possible Solutions: This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect the intake air system for air or vacuum leaks and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.
If you have an advanced scan tool that can interact with the car, command the idle higher and lower to see if the engine responds appropriately. Also check the PCV valve to see if it's blocked and needs to be replaced. Check the IAC (idle air controller) if equipped, verify it's operation. If available, try swapping in a new throttle body to see if that fixes the problem. On Nissan Altimas and possibly other vehicles the problem may be fixed by having the dealer perform an idle air relearn procedure, or other relearn procedures.
Hope helps.
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
127 views
Usually answered in minutes!
×