Replaced failed injector, car wont run as unable to input new injector code as unable to connect to ECM. how can I clear the P1000 fault code. Regards Stuart.
SOURCE: need to know what a p1000 diagnostic code means for a jaguar s ty
Looks like you have acommunication problem with the computer, it is going in to safe mode. Check all computer connections before you go to jaguar.
I have attached a picture of the error code.
hope this helps
SOURCE: failsafe engine mode light comes on, codes
Just a quick mention - for about a month my XK8 low coolant light came on intermittently. This week with no notice while driving normally I got Stability Control Fail and FailSafe Engine Mode and wtih great difficulty got the car back to where I started from (less than a mile). Two days later (when got time) and after a bit of research, I tried it again - same problem and a very unhappy engine. I then disconnected the battery for 15 minutes (probably more) to clear the engine codes as well as check all the wiring and vacuum stuff I could under the hood (at a Jaguar master mechanic's recommendation). No problems found but the car would start and immediately stall with the air intake hose disconnected from the intake butterfly. After I reconnected the air intake hose, she started and purred like normal. The problem is the BATTERY... It is low - I've known it for a LONG time BUT it always started right up and never skipped a beat. I intend to replace it tonight but fully expect that's the issue. I've had the car 6 years (it's a 98) and had NO problems except a dead taillight asembly.
Hope this is of value...
SOURCE: Have error codes C1175 &
C1175
ABS/TCCM
Anti-lock braking / traction control
LH rear wheel speed sensor circuit fault
ABS/TCCM to wheel speed sensor signal circuit (FH33-21): open circuit,
short circuit to ground, short circuit to B+ voltage, high resistance
LH rear wheel speed sensor failure
P1000 is for check not complete after last memory clear , dont worry about it , just stick with C1175 , and most probably it is the sensor wire
SOURCE: fault code p0251
hi there,
the fault codes you listed correspond to these..
.P1000 ..OBD Systems Readiness Test Not Complete
P0251 Injection Pump Fuel Metering Control.
hope this helps, if so, can you leave me feedback please
Testimonial: "helpfull tip "
SOURCE: what dose the code p1000 mean and p1645
P1645 EVAP Solenoid Output Circuit
P1000 Scan not complete. meaning it didnt finish scanning
365 views
Usually answered in minutes!
×