Auto stalls after starting and running good
SOURCE: 1995 ford taurus stalled and will not start
Okay had some thing like this happen to me ,First dose your car smell like something like plastic is burning under the hood ? If not try having your mech do a scann on your car . I found than they can pin point but my car totally baffled them It would run after replacing every senor. My mechanic also found the big problem There is a big bundle of wires runiing behind the engine. Just above the rear manifold .(back spark plugs) Look down and see a wire harness it can get on the manifold and melt throught the thick insulation and burn wires and give false codes .this wire harnes and the big bundle of wires run the whole car so be car full
SOURCE: my 1994 ford taurus 3.0
Check to make sure it is getting fuel. I had a taurus that was notorious for not starting once the fuel filter got dirty. It is located on the fuel line mounted to the floor of the car directly under the rear passenger door. If it is getting fuel than the next thing to check is, is it getting spark if no spark this could be caused by a bad ignition coil or worst case scenario a broken timing belt.
SOURCE: car stalls after running for a while
Check your coil and crankshaft position sensor What are your engine codes
SOURCE: Ford taurus check engine light code 1663
the last i heard this was adealers erg code,no its not a joke
SOURCE: put in new alternator 98 ford taurus dohc car will start thn stop
Check mega fuse. Side of fuse box under hood. Slide cover off and test both studs. Should have 12 volts on both studs. If not. Fuse blow.
193 views
Usually answered in minutes!
×