SOURCE: replacing bad camshaft position sensor
Reverse procedure to install and prior to installing new sensor, lubricate sensor O-ring.
It is located under the water pump. Make sure when you remove the sensor that you rotate the crank shaft and look in the hole to make sure the pick up magnet is still in there. Sometimes they come loose and cause a no start or long crank. You will need to have the code cleared still.
SOURCE: 2003 chrysler 300m o2 sensor and camshaft position sensor
SOUNDS LIKE YOU HAVE CAMSHAFT DAMAGE.
SOURCE: locating and replacing a camshaft sensor in a 2005 dodge neon
this is a very very simple procedure. you do not need pics. there is a sensor located at the end of the engine on the far side from the belts. at the top. it has a plug with two wires in it. just remove the two 10mm bolts un hook the plug and reverse the process to reinstall. if you have a factory intake you may have to remove it to access this sensor. just the intake tube.
SOURCE: BMW X5 CAMSHAFT POSITION SENSOR A .SHOW DIAGRAM
hi i have a diagram if you would like it i could email it to you and there are 2 of them does it say which one it is? you can email me at
[email protected]
and i will send you the diagram hope this helps
SOURCE: i need to find out
The cam sensor is on the back of the engine, drivers side. On the side of the head, facing the wheel. Just under the rocker arm cover. Only thing on that side. Four bolts to remove it.
59 views
Usually answered in minutes!
×