2000 Nissan Maxima Logo

Related Topics:

A
Anonymous Posted on Apr 04, 2014

Nissan sentra 160gxi twincam 16 valve iac valve were is it in engine

5 Related Answers

Anonymous

  • 70 Answers
  • Posted on Apr 25, 2009

SOURCE: locate fuel filter on 2007 nissan sentra 2.0 liter engine

its in the gas tank but it doesnt have to be changed!!!YAY

Ad

Anonymous

  • 8 Answers
  • Posted on May 29, 2009

SOURCE: engine head torque settings for 2005 nissan sentra 1.8

email me ill send you it via email cant post here too bigg!!

Anonymous

  • 11896 Answers
  • Posted on Aug 04, 2009

SOURCE: 1995 Nissan Sentra, The engine light and brake

You could have faulty altenator or short causing the battery to drain. The engine light usually comes on when anything electrical or sensor wise is faulty. Brake light will come on if, low brake fluid, e-brake handle is up.

Anonymous

  • 2317 Answers
  • Posted on May 12, 2010

SOURCE: service engine code P0302 2000 nissan sentra

I would check that spark plug, and have that coil checked or replaced. Also check for any vacuum hose leaks in the area of the cylinder.

Anonymous

  • 906 Answers
  • Posted on Aug 03, 2010

SOURCE: I need to see an engine diagram for a 1996 nissan...

good day Sir, try this link owners manual i hope this will help.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to adjust iac valve on 2001 Nissan Sentra 1.8 liter engine

you dont ... you clean or replace it
its a non repair item ..... throw away if it doesnt work
0helpful
1answer

My nissan sentra 1998 model twincam 16 valve dohc has a idling problem the idle drops when foot brake is pressed to 0.3rpm & comes back to 0.9rpm tried advancing timming worked for a while then same...

diaphragm in servo split ,is my first choice of answer ,block off servo pipe from manifold with a cork of something and try applying the brakes then ,if ok then you have the problem ,stop looking for fancy excuses and faults that do not exist .If in doubt ask local recomended mechanic .
0helpful
1answer

Nissan sentra 1.6 16valve timing marks

Hi I got problem with a Nissan sarbe 160gxi after the head gasket blown i send the head to get sorted out the car don't have a same power I'm not sure if the guys set my cams right . I feel the timing on plug leads r to advance its pining . It was also low on gas . 156 km
0helpful
1answer

A 1985 Sentra - The engine idles until warm then it dies.

has it got a idle control valve, have tried adusting throttle cable slightly
4helpful
4answers

Torque settings for cylinder head nissan sentra

Tighten in sequence to 29ft.lbs then tighten in sequence to 58ft lbs. then loosen all bolts. Then tighten in sequence to 33ft lbs. then tighten each bolt in sequence 90 degrees then tighten each bolt again 90 degrees
0helpful
1answer

Ac problem

Possible base idle adjustment or bad IAC valve. Could also be the A/C circuit. Check to see if the cars idle goes up when you are still and at idle. The idle should come up some, maybe about 150 rpm's or so. If that's OK, that I would have your base idle checked along with the IAC valve circuit and the valve itself. Let me know wht you find.
0helpful
1answer

Low rpm in D or R when engine is hot

how about cleaning the mass air filter wid electronic cleaning spray.
Not finding what you are looking for?

46 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...