Core heater located

ZJ Limited

• 17989 Answers
• Posted on Nov 04, 2009

SOURCE: Where is the heater core located in a chrysler New

Definitely not a do-it-yourself project. It involves discharging the air conditioning system and pulling the steering column and dashboard.

Hope helped.

SOURCE: trying to find location of blower on 2002 chrysler

under the glove box,pull out plastic push pin holding plastic duct work and remove duct piece,three screws holding blower motor cover,remove them,then disconnect blower motor wires at connector,remove three screws holding motor up in place.
watch the mice don't fall on you!

Ronny Bennett Sr.

• 6988 Answers
• Posted on Jun 06, 2010

SOURCE: i have a 2002 pt cruiser. it is leaking coolant

Yes,I am afraid so,the heater core will have to be replaced.

Duane Wong

• 6826 Answers
• Posted on Oct 13, 2010

SOURCE: heater core. where is it

Heater Core REMOVAL & INSTALLATION For the removal of the heater core, which is located inside the heater-A/C unit assembly, first remove the heater-A/C unit assembly from the vehicle as described later in this section. Once the unit has been removed, use the following procedure to extract the heater core:

1. Place the heater-A/C unit on a suitable work surface.
2. Locate and remove one retaining nut from the blend-air door pivot shaft.
3. To remove the top cover from the heater-A/C case, the crank arm must be removed.
4. Disconnect the vacuum lines from the defroster and panel mode vacuum actuators and position them out of the way.
5. Remove the 3 heater-A/C unit cover attaching screws, fastened upward at the defroster outlet chamber.
6. Remove the 2 heater-A/C unit cover attaching screws, fastened upward at the air inlet plenum.
7. Remove the 11 heater-A/C unit cover attaching screws, fastened downward into the housing. Then lift the cover from the heater-A/C unit.
8. Remove the old heater core from the case. To install:
   
9. Install the new heater core into the heater-A/C unit case in the same position as the old one.
10. Place the cover onto the case and secure in place with the 11 retaining screws.
11. Install the 2 heater-A/C unit cover attaching screws in the air inlet plenum.
12. Install the 3 heater-A/C unit cover attaching screws in the defroster outlet chamber.
13. Attach the vacuum lines from the defroster and panel mode vacuum actuators to the heater-A/C unit case.
14. Install the crank arm and the retaining nut on the blend-air door pivot shaft.
15. Install the heater-A/C unit assembly into the vehicle.

SOURCE: where is the heater core

IT'S BEHIND THE GLOVE BOX. IT IS NOT EASY TO REPLACE.....



REMEMBER TO RATE THIS ANSWER

THANK YOU

Testimonial: "thank you. i have been searching. you are the only one to give me a straight answer."