It sounds like im having exhaust problems. my temperature gauge is on when i crank up my car but it goes off. the car is not running out. what elase can make a car run hot
SOURCE: Ford Crown Vic p0300 random cylinder misfire
take a look at the EGR valve it could be either vacum controlled or electronic either way what seems to be the problem is that the valve is stuck in the open position until the engine warms up you can gently tap the egr valve with a small hammer or a screw driver and you can see that it runs smooth, now if the egr valve is vacum controlled replace the valve. if it is electronoc controlled replace the valve and the module for the egr valve.
SOURCE: temperature gauge goes up and oil light goes on
It's overheating. check thermostat and water pump, also radiator coolant levels. once you get it running at normal temp again take it to the shop and have them do a chemical test to see if the head gasket was damaged or the block was warped or cracked as this usually happens when your car overheats.
SOURCE: Wiper motor replacement for a 99 crown vic
I replaced the same part on a 1994 Crown Vic. There are a few bolts which go through rubber mounts on the firewall and that is how the wiper motor fits against the firewall. There is a clip on the wiper drive that must be pressed and slid off the wiper shaft. The hardest part was getting clearence between the engine and wiper motor. If I remember there was a way to turn the wiper case to clear the engine. I have asked myself why this was engineered like this? There is nothing important in the way that 3/4" of clearance could have been given for removal.
SOURCE: 1998 ford crown vic sputters
I would try to replace your spark plugs, and spark plug wires, My 88 Vic did the same thing...now it runs like a champ....you could also try fuel injector cleaner.
SOURCE: 99 crown vic wont crank when i turn the key
Turn key to the run positio, Press on your brake and run your shifter through the gears a couple opf imes then try starting in neutral. This is for the benefit f the neutral safety switch. If still nothing , Raise the hood and and check the battery for a bad or corroded connection. If all is good, make sure car is in park. There is on the driverside fenderwell a relay that looks like a mine Roun With two small terminals and tw large terinals o opposite ides.. When you turn to crank, you put cirrent to one of the small ter minals and that causes the two large battery cables to connect and give power to the starter. If you can jump the battery side cable and the starter side post the starter will crank if nothing is wrong withe the starter.the two large posts. Use a jumper cable,NOT a coat hanger, iF THE STARTER SPINS THEN START IT WITH THE KEY. Good Luck.. Any more help let me know.
35 views
Usually answered in minutes!
×