Bmw x3 problems

05 Chrysler pacifica is a 4 speed automatic, next time buy a car with a 5 speed automatic

A lot of the newer vehicles have speed sensors, do you get any codes.?

find a tranny man,
any ASE shop works
ask em.' to CHeck it out.

check and replace the TCM

Check the transmission computer

This is a fault mode in which the transmission either loses electrical power or the PCM deactivates all of the electronics. The transmission will default to max line pressure. The driver will have Reverse and 3rd, with manual 2nd available by putting the gearshift in 2 or 1 (doesn't matter). 1st, 4th, and TCC lockup will not be available. It will not hurt the car to drive it like this for short periods, but use manual 2nd to get the car moving, and be aware that the trans will generate more heat than normal while operating in limp-home mode due to increased torque converter slippage during 2nd gear starts and no lockup in 3rd gear.

Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.

No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : ShiftA solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, once it's moving you put it back in OD and the car shifts 3rd to 4th on its own and locks the converter at the appropriate time: ShiftB solenoid failed: Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Hi All

I have a s40 1.9d / 2000 plate,
In the last month or so the car loses revs when changing up to 3rd and 4th gear, I can only get 50 mph max in 3rd gear 80mp in 4th.
The car has just clocked 185,000 miles
Its a great car but a pai at the moment, I've had a service including fuel fillter change added fuel cleaners to the deilsel all to no avail


Any suggestions

Need to pull codes 1st, the electronics of the transmission can cease all proper operation of the transmission. Have the DTC's checked before proceeding.

Doesn't sound like a simple fix. I would suggest having it serviced.

Check that the OD solenoid on the torque converter is good still. When the R4 wont go into OD you have no more gears than 1st an 2nd. If the OD clutch drum was relaced if it was burnt, that will make a problem also. You have to have OD in order for these babies to work right.