Clutch was disengaging when it popped. felt something hit my foot and found the weld. shook the pedal and out dropped the plastic! what do i need to buy to fix?
SOURCE: Emergency break pedal stuck to floor, but break is disengaged
sounds like your brake cable has broken or there is something damaged in the pedal assembly.........try pulling on the release handle and move the e-brake pedal back to its off position by hand at the same time.(you may have to tie it in this position to keep it up)If that doesnt work there is a sensor on the pedal assembly that you should be able to bypass by either disconecting the wire(1 wire system) or connecting the two wires together (2 wire system)Especially if your truck is a standard the e-brake is an important safety feature,so if these steps fix the light and dinging problem you should still take the steps to have it repaired.
hope this helps.........Good Luck!
SOURCE: Audi 500 SEL 1995/6 - South Africa
May be the clutch master or slave cylinder. Has the fluid level gone down at all? Have a look around the clutch pedal area for signs of fluid leakage. Good luck, Bob.
SOURCE: clutch pedal went to the floor but did not come
there is a plastic clip that connects the clutch pedal to the rod that goes to the master cylinder, chances are that it let go. Bad thing is that it is only available from GM along with the rod. It is around 50
106 views
Usually answered in minutes!
×