Where are the two wires located and what two colors are they for the IAT on my 1991 nissan sentra 2 door 1.6L
SOURCE: need to bypass ignition switch on nissan sentra
it should be underneath your car in between the firewall and the engine. Now you don't want to supply direct power to your starter because you'll end up frying it. However to just start the car once you've located the starter, get a long screwdriver with a plastic handle and connect the two wires with the screwdriver.
As for a long term fix, without investing the money to replace the necessary parts. You will need to attach a wire that can handle 12v to both wires on your starter separately. Then connect the other ends of both wires to a switch that can handle 12v, and mount that in your car somewhere. Then whenever you need to start your car just flip the switch on until the car starts then once it is started flip it back off.
I know this sounds like a lot but it is very doable with about $5 and a little bit of time.
SOURCE: iat sensor location for a 2002 nissan frontier?
Depending on what size engine you have, it could be on the air filter housing,or somewhere along the intake tube that goes to the throttle body. It's round in shape and has 1 or 2 wires connected to it.Without the size of the engine, I can't tell you exactly where it is.
SOURCE: 1997 nissan pathfider iat sensor
i believe it is built together with the mass airflow sensor!
SOURCE: I have a 2003 Nissan Sentra SE-R Spec V. o2 sensor location?!?1
theres always one on the intake manifold working its way down to catalytic convertor is the oxygen sensor 1 heater circuit(pre cat conv) signal while terminal #25 is oxygen sensor 2 heater circuit (post cat conv)
172 views
Usually answered in minutes!
×