Hub nut torque setting
If you mean the bolts that hold the back-plate, tighten to 35 ftlbs. If you mean the hub nut that hold the bearing assembly, tighten till firm, then back off the nut and tighten till there is no play in the bearing assembly. Do this with the wheel on. Now use the ca adjustment. Put the cap on and you are done.ge and split pin to hold the
SOURCE: need torque setting for front hub nut on a mark 3 golf vr6
195 ft-lbs I verified this in the Volkswagen repair manual aka the vdubbers bible
SOURCE: VW Jetta torque setting and hub nut size????
129 ft/lbs. Per Bentley...I'm pretty sure it's a 30 mm 12 point socket.
SOURCE: torque setting for hub nut for skoda octavia 1998
I'd recommend you register for free at www.autozone.com Once registered you'll have access to repair and shop manuals for virtually any car or truck. All the data and diagrams you need now or may need in the future will be a couple of mouse clicks away.
SOURCE: want to know Torque setting
front wheel drive then a good pull on a decent bar is sufficient ,if older rear wheel drive vehicle then this is different as they are taper bearings and sholud not be over tightened ,just pinch up till whell doesnt wobble when grasped at the top and bottom
Rear hub and bearing
Click to Enlarge
To install:
Rear hub and bearing
Click to Enlarge
Rear hub removal
Inner wheel bearing removal-rear hub/bearing
Rear wheel bearing removal-2wd
Rear wheel bearing removal-4wd
To install:
Install or connect the following:
Rear wheel bearing installation
hope this helps if so send testimonial comment or even any other questions you have
842 views
Usually answered in minutes!
×