- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
P2189: Sys Too Lean at Idle Bank2 P2187: Sys Too Lean at Idle Bank1
The other codes P2189PD & P2187PD are pending codes.. Meaning the car will have to recheck the errors before it calls it an error and sets the engine light on. They are the same codes as the others just the PD at the end means pending.
I've come across these codes before. In almost every case there was an air leak in the intake air hose (hose between the engine air filter & the throttle body). Inspect this hose & tubes attached to it. This is especially true when the lean code includes the comment 'at idle' P2187 - System too lean at idle Bank 1 P0174 - System too lean Bank 2 P2189 - System too lean at idle Bank 2 P2195 = HO2S Signal Biased/Stuck Lean (Bank 1 Sensor 1) P2270 = HO2S Signal Stuck Lean (Bank 1 Sensor 2) P2272 = HO2S Signal Stuck Lean (Bank 2 Sensor 2)
P2187 & P2189 = In order to provide the best possible combination of drivability, fuel economy and emission control, the PCM uses a closed loop air/fuel metering system. The PCM monitors the HO2S signal voltage and adjusts fuel delivery based in closed loop fuel control. Changes in fuel delivery will be indicated by the long-term and the short-term fuel trim values. The ideal fuel trim value is around 0%. The PCM will add fuel when the HO2S signal is indicating a lean condition. Additional fuel is indicated by fuel trim values that are above 0%. The PCM will reduce fuel when the HO2S signal is indicating a rich condition. Reduction in fuel is indicated by fuel trim values that are below 0%. The DTC relevant to fuel trim will be set when the amount reaches excessive levels because of a lean or rich condition
P0455 Evaporative Emission Control System Leak Detected (large leak)P2198 O2 Sensor Signal Stuck Rich (Bank 2 Sensor 1)P2189 System Too Lean at Idle (Bank 2)P2187 System Too Lean at Idle (Bank 1)P2196 O2 Sensor Signal Stuck Rich (Bank 1 Sensor 1)
basically you need to replace either the air /fuel ratio sensor,, or,,the heater relay associated with that sensor,, these are very hard to diagnose without the hand held or scope that narrows it down ,, you can check a multitude of voltages on a number of electrical connections, as far as the P0455 ,, if you installed a new gas cap either have the code removed , or wait a couple of days and it should remove itself, as long as the cap is factory approved, Look for vacuum leaks in the evap system , cut hoses,, bad connections,
code p2189 and p2187 = air/fuel mixture too lean on both cylinder banks which in turn generates excessive emissions = failed inspection.
What can cause a lean mixture: - Incorrect main charge signal - Intake air system leaking - Fuel pressure too low - Volume supply of fuel pump too low - Mechanical fault in injectors - PCV valve leaks - Leaks in exhaust system - EVAP canister purge valve mechanically faulty (hangs open) All these must be checked.
×