Stuck glove compartment

To remove the glove compartment on a 2007 Lexus LS460, you will need to first open the compartment. Then, you will need to locate the mounting screws that hold the compartment in place. These screws are usually located on the sides or bottom of the compartment. Once you have found the screws, use a screwdriver to remove them. After the screws have been removed, the glove compartment should be able to be gently pulled away from the dashboard. If the compartment is stuck, you may need to carefully pry it away using a flat tool like a screwdriver or a trim panel tool. Be careful not to damage the dashboard or the glove compartment as you remove it. Once the glove compartment has been removed, you can access the area behind it for maintenance or repair.

Brute force and get a new one from a breaker.

If you look under glove box you will see two to four screws that hold the glove box on. Take out the screws and the glove box will drop down and you can get inside and release latch..then you can get a replacement latch and replace.

SEND ME VIN AND AN EMAIL TO SEND U MORE INFO....

The blower motor resistor module is located behind the glove compartment, mounted to the blower motor. There is a release lever in the rear left of the glove box, push this lever to allow the glove box to drop down completely.

pry it

Open glove compartment. Press inward at both sides of the glove compartment, then lower the glove compartment.Remove the lower side instrument panel and crash trim pad. Remove the four glove compartment upper cover retaining screws, then the cover. Remove the two glove compartment retaining bolts, then the glove compartment. Press on the cabin air filter cover tab, then remove the cove
Remove the cabin air filter from the blower unit opening. Install a new cabin filter, ensuring the air flow marking is facing in the proper direction. Install the cabin air filter cover, ensuring the cover is properly installed.
Position the glove compartment to the instrument panel, then install the two retaining bolts. Install the glove compartment upper cover. Install the lower side instrument panel crash pad. Lift the glove compartment into position. Close the glove compartment.

take a small precesion screwdriver and push the lever inside the housing ,that should do it.hope this helps

yes it is common on these type of cars to see if the linkage in side the glove compartment is not stuck use a screw driver and sloely pull it should get a grip then and operate perfectly

hello / if you move the glove box door from side to side when pulling on it , it will open one side first and then the other side . it has 2 hooks one left and one right / hard to explain ,/