928 s4 Porsche 300 kw 32 valve V8 key cutting problem. No key cutters in New Zealand can do it. We have found places that have blank keys but no machinery to cut the angle.
SOURCE: broken ignition barrel ford laser 1989 model
Hi,
this is the procedure to remove the ignition barrel:
Remove the steering column surround and you should see a black round
thing on the left hand side, this is the ignition switch. Remove this
and you will see there is one screw holding the ignition barrel on,
remove and you then need to insert your key and turn it to the ACC
position. you should now be able to withdraw the barrel using the key
but take care not to snap the key off in the barrel.
Please don't forget to rate or accept the solution as fixya.
Goodluck..
SOURCE: reprogramming remote and key
if its early 05 round heart shaped remote it needs programming into system at dealer with Tech2
later 05 to 07 had square (rectangle) shaped remote
1.2 ID Code Additional Registration
Note: This procedure will add additional remotes to the Keyless Entry Control Units memory. A total of 4 remote transmitters may be programmed into the Keyless Entry Control Units memory. When a total of registered and newly registered remotes exceed 4, the oldest one shall be erased.
Step Action
1 Note: Make sure that all the doors are closed and unlocked. Insert the ignition key into the ignition switch.
Open the driver's side door.
2 Turn the Ignition key to the “ON” position and then to the “LOCK” position three times
(The key should remain in the “LOCK” position)
Note: This step must be carried out within five seconds.
3 “CLOSE” and “OPEN” the driver’s doors once (Leaving the driver’s door in the “OPEN” position)
Note: This step must be carried out within five seconds after step 2 is completed.
4 Wait for 8 seconds (This wait time is critical)
5 Turn the Ignition key “ON” and then to the “LOCK” position once and turn key to the “ON” position (The key should remain in the “ON” position)
OR on/lock once
Note: This step must be carried out eight seconds after step 3 is completed.
6 “CLOSE” the driver’s door
The HAZARD lights should flash 3 times (This acknowledges the Keyless Entry Control Unit has entered programming mode)
7 Operate the lock or unlock button of the transmitters to be programmed; a flash of the HAZARD lights indicates the remote has been successfully programmed into the control unit
8 The HAZARD lights will flash approx 4 seconds after pressing the remote button to indicate the Keyless Entry Control Unit has exited programming mode.
SOURCE: Having a challenge programming a 1999 Lexus RX 300 newly cut key.
did the lock smith cut key with resister in in maybee not gotta go to dealer get one cut then put old key in start car then turn of remove key put new key in turn on till security light goes out then start car
SOURCE: I need a new key for Porsche Boxster 1997
Only the dealership my friend and it`s going to cost ya.
264 views
Usually answered in minutes!
×