Hi. P0650 : check engine light bulb burn or disconnected.
P0734 : pulse generator sensor no signal
1: replace light bulb on instrument cluster
2: replace sensor on transmission
3: clear computer code and drive 15-20 min.
If the P0734 come back transmission need to be rebuilt
Use factory recommended fluid only.
good luck
Why did he or she say this?? Did he or she do the diagnostics for the fault codes or did they just guess??
SOURCE: 2002 hyundai accent codes p1529 and p0734
P1529 means nothing more than the TCM (transmission control module) has
requested that the ECM (engine control module) turn on the check engine
lamp.
P0734 basically indicates that your transmission is slipping.
You need to take this car to an authorized repair center for hyundai cars. Replacing the filter and fluid on the transmission might save this transmission but I would be willing to bet that a total transmission rebuild is in order.
Good Luck
SOURCE: vehicle wont change up into gear reverse gear not
P0734 - 4th gear incorrect ratio. P1529 Malfunction Indicator Lamp Request. Problem is in the transmission.
Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.
SOURCE: 2002 hyundai accent.transmission works great
Hi
Well two of the tranny codes ; P0734 and PO732 indicate gear 2,3,4 ratio incorrect. This can be caused by poor readings at the input and output speed sensors or pulse generators. The P1709 code is in reference to the kickdown servo switch.
Replacing the pulse generator set and TCM reprogramming( as per TSB) may solve your problem, otherwise you have a major component failure in the transmission unit. I would get some line pressures at the transmission checked first.
Sounds like the transmission is in fail safe mode, this happens when there is a transmission fault, you only have two gears 2nd and reverse.
Hope this helps - Steve
SOURCE: I have had the transmission rebuilt in my 2002
Code 0734 : Gear 4 Incorrect Ratio. you may wanna take back to the Mechanic and tell him whats going on and let him deal with that. Good luck
586 views
Usually answered in minutes!
×