Power locks and windows

We don't know make, model, year of car/truck you drive, Brian. How about reposting your question with this important information.

Torque converter or broken drive

Battery fauilt sounds like low voltage

did you check the fluid in the transmissin it could be low or also it could need a new transmission filter i wouldnt try to drive it it anymore without checkin or changin it because it will burn it up

replace the alternator,this is the problem,please rate thank you.

Sounds like a bad master switch, bad wiring to the drivers door, or bad body control module.

You need to have the BCM scanned for faults.

Put your transmission in nuetral then shift back to 4 high then put in park and back to drive.
Lone99star

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/jason_77a19afa8d604dee

It sounds like you new switch needs adjusted just a little bit.

Last night I checked the battery and it was still good. I disconnected and then reconn ected both terminals and that brought the power back. When I turned the key the power went out again. I repeated the procedure but did not turn the key. Instead, I took off the knee bolster and tried to wiggle the wires under the dash to see if I could find the source since it seems to be related to the ignition. Nothing cut the power so I started it up and it worked fine except for the check engine light which was flashing that says I have a misfire condition. I drove the car 25 miles to work this morning and will be taking it to the dealer for a better inspection.