Jeep Grand Cherokee Limited P0700 diagnostic problem

Question edited to fix second code.
Grand Cherokee P0700 Code Definition If you are scanning your vehicle right now, you should be looking for a second code that tells you what is actually wrong. Think about it like this.

• P0700 Says- "Hey there's something wrong with this transmission.
• The Next Code(s) Say- "I'm the actual problem going on with the transmission. I'm what you're looking for."

Ways to fix
https://www.google.com/search?q=jeep+grand+cherokee+p0700+problem

And P0038

Jeep P0038 HO2S Heater Control Circuit High Bank 1 Sensor 2

https://www.carobdcodes.com > jeep-p0038-ho2s-heate...
OBD-II Trouble Code Description for P0038 Jeep ... Jeep Grand Cherokee SRT8,2006 Jeep Commander 4×4 Limited 5.7 HEMI,2005 Jeep Wrangler UK Version,2005 Jeep ...

P0038 JEEP Code - O2 Sensor 1/2 Heater Circuit High

https://www.autocodes.com > p0038_jeep
Jul 13, 2020 - Repair Information for P0038 Jeep code. Learn what O2 Sensor 1/2 Heater Circuit High means, location and how to repair?

..

Reasonable explanation can be found at the links below...

https://www.obd-codes.com/p0700

https://www.obd-codes.com/forums/viewtopic.php?t=18818

Here is a good forum to check out for your P0700 code
http://www.obd-codes.com/forums/viewtopic.php?f=1&t=8914

That code is for the engine coolant temperature sensor. "...input above maximum acceptable voltage." I would try a new temp. sensor. If that doesn't fix it, you may need to have an engine scanner hooked up, and see what the sensor is sending to the computer, and go from there.
A bad coolant temp. sensor can cause hard starting like your symptoms.
.

p0340 cam shaft position sensor malfunction,P0700 Transmission Control System Malfunction, P0703 Torque Converter/Brake Switch B Circuit Malfunction,
P1652 P 1 6 5 2 OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering O2 Sensor Heater Circuit Malfunction Turbocharger Boost Sensor A Circuit Low Crankshaft Position Sensor A Circuit Low Input

i want a ? xxxxxxxx
the dealer sells them. call them and ask, em.?
fleabay has them used.

or the hope thing.
http://www.ebay.com/sch/i.html?_sacat=0&_from=R40&_nkw=1999+jeep+grand+cherokee+operators+guide&_nkwusc=1999+jeep+grand+cherokee+opeators+guide&_rdc=1

possible causes
Shorted or open circuit within Transmission Control Module (TCM)
- Faulty Transmission Control Module (TCM)
symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Driveability problems
- Transmission shifting problems
p0700 description
The transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. When the TCM detects a malfunction with the control, a signal is send to the Engine Control Module (ECM) to trigger the Engine Light or Service Engine Soon light. The ECM stores the P0700 code and it means the TCM detected a malfunction with the transaxle controls.

Read more: http://engine-codes.com/p0700_jeep.html#ixzz2hihK6PVo

P0700 Transmission Control System Malfunction
P0730 Incorrect Gear Ratio
P0620 Generator Control Circuit Malfunction
P1130 Not found
P0340 Camshaft Position Sensor Circuit Malfunction

google grand cherokee forums join some of them and ask there

I had this problem on a 99 grand cherokee limited, It was the heater blend doors and if you have dual climate control one side usually goes out before the other. These blend doors are located behind the glove box unaccessible inside the HVAC shell.
(http://www.wjjeeps.com/hvac_sub_assembly.htm) Motor failures for this HVAC sub assemblies is also something to look for although much less common.
My local dealership estimated $$$$$$$$$950.00 because they have to remove the entire dash so I looked around for something else.
http://cgi.ebay.com/ebaymotors/Blen-Dor-Jeep-Grand-Cherokee-Blend-Door-Heater-Repair_W0QQcmdZViewItemQQhashZitem3eef1e1cd6QQitemZ270299700438QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

I used something similar to this and now have heat that is controlled solely by the knob nearest the driver. It wasn't very difficult just kind of a tight squeeze.
Hope this helps
GOOD LUCK