Cruisecontroldoesntwork cruise control light on panel lights up but cruise control does not work

Check your repair manual where the vacuum hoses for the cruise controls are (engine bay). Maybe one of the hoses came off or has a leak.

Try checking the small switch at the top of the brake pedal. There may be two one for brake lights and one for the cruise control. To ascertain what is what, pull one wire off and see if brake lights work. If not, then the other switch controls the cruise control disconnect and engage..I you have a DC test light check to see if power is on on both side of the switch with brake pedal up. If so, depress pedal and check power on the other side there should be none, if there is the switch is defective.

check cruise control fuse and check the brake lights see if brake light working because the brake light switch will deactivate cruise control when brakes is applied.if brake lights dont work either fuse blowed or switch bad.if all is good have vechicle code scan because cruise control control by PCM and vechicle speed sensor and thottle actuator control motor.

1. check fuses - owners manual.
2. check relays in engine compartment - owners manual
3. check the cruse controler and cable connected to the carb./throttle body.
4. wiring

no, no reset.

you have disconnected the cruse wire. look for the cruse servo,

Check that the cruise control module fuses are not blown in the fuse panel. Also make sure your stop lights are working; cruise controls are designed to disengage when the brakes are applied, and one method of sensing that is to monitor brake light current.


then reset your four wheel drive again

abs asr light on and cruise control stop working

You have a short somewhere dude

Could be the plunger motor/ vaccum plunger under the hood. If the cruise light is on, the computer thinks it is working.