2002 Land Rover Discovery Series II Logo
t
troy dawson Posted on Mar 07, 2014

My 02 land rover discovery 2 turns over but wont start

Change starter and crank shaft position sensor

  • Anonymous Mar 07, 2014

    If it's turning over chances are the starter is working. Next would be to check for spark and fuel.

×

1 Answer

Bryan Andrews

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Cheetah:

An expert who has answered 20 or more questions within one hour.

  • Contributor 45 Answers
  • Posted on Mar 07, 2014
Bryan Andrews
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Cheetah:

An expert who has answered 20 or more questions within one hour.

Joined: Feb 27, 2014
Answers
45
Questions
0
Helped
16171
Points
88

Check fuel pump, fuel pump relay, and also check inertia switch. In ertia switch is usually located inside the cabin on the driverside fire wall on most Ford products.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Apr 12, 2010

SOURCE: WHERE IS THE FUEL FILTER LOCATED ON LAND ROVER DISCOVERY 2000

LAND ROVER DISCOVERY II DONT HAVE FUEL FILTER, ONLY HAVE PRE FILTER IN THE FUEL PUMP

Ad

Anonymous

  • 1 Answer
  • Posted on Feb 24, 2009

SOURCE: 1998 land rover discovery won't start

I just expiriance the same problems on my rover so i check it out and found that the engine spark fuse was out. I replaced the said fuse and their you go it started. You can find that fuse under the dashboard in the satellite 1 fuse box. it should be the 3rd one from the right. Good luck buddy hope that helps you out.

Anonymous

  • 218 Answers
  • Posted on May 15, 2009

SOURCE: Radio in 2000 Land Rover Discovery

THERE SHOULD BE A RADIO CODE CARD WITH THE VEHICLES PAPER WORK.IF NOT U HAVE TO CALL THE DEALER FOR THE CODE.

Anonymous

  • 149 Answers
  • Posted on Feb 24, 2010

SOURCE: how to adjust rocker shaft on discovery td5

There are adjustment screws on the rockets according to RAVE.
The procedure is as follows:
1) Rotate the engine clockwise until No 1 injector lobe is at full lift.
2) Rotate rocker adjusting screw clockwise until the injector plunger is felt to bottom out.
3) Rotate rocket adjusting screw anti-clockwise one complete turn to give plunger the required bump clearance and tighten rocker arm adjusting screw locknut to 16Nm. Ensure the screw does not turn as the locknut is tightened.
4) Carry out the procedure for the remaining 4 rocker arms.
5) After completion of rocker arm adjustment slowly rotate engine clockwise 2 complete turns by hand to ensure that no injectors are bottoming out on their plungers.

Anonymous

  • 149 Answers
  • Posted on Feb 25, 2010

SOURCE: transfer case oil change- 1999 Land Rover Discovery II

No need for a diagram, to drain the oil, there's a drain plug on the bottom of the transfer box, under the handbrake drum. To fill, the fill plug is about in line with the centre of the handbrake drum and to the left. I think both plugs are 1/2" square. Fill to overflow with Texaco Multi-Gear 75W/90R. Takes about 2L or so.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2002 free lander wont start every now and then it turns over

run fault codes and check for cam/crank position sensor. Check that the immobiliser is operational. Check that the cam shaft is turning (broken timing belt/chain)
0helpful
1answer

02 land rover discovery turns over but wont start

OTHER THAN A MECHANICAL PROBLEM THERE ARE 2 THINGS THAT KEEP YOUR CAR FROM RUNNING, 1 No Spark, 2 No fuel. To check fuel open the air intake and squirt a little fuel into the air intake if the car starts or at least fires you probably have a loss of fuel.. The spark problem, You need to find out if the spark plugs are firing.. if they are not firing the car will not start.. THEN YOU MUST FIND OUT WHY THERE IS NO FUEL OR NO SPARK, BUT FIRST Isolate the system THAT IS NOT functioning.


0helpful
1answer

Install new crank sensor on 2001 land rover discovery, now it doesn't start

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

0helpful
1answer

My land rover discovery 1 1995 won't start i get

You need a noid light for that but since they are all not firing it's most likely the cam shaft position sensor. That tells the computer the cam shaft position so it knows when to pulse each injector. Let me know if that's it. The cam shaft sensor should be pretty cheap.
0helpful
1answer

Engine is not running after spark plugs and cables changed.

I assume it was running before you changed the plugs and wires, verify you didnt disconnect accidently another wire such as a crank position sensor or an oxygen sensor on or near exhaust manifold
also check the wire firing order make sure that is correct...
0helpful
1answer

Land rover 1999 starter is running but engine wont start

the unit where u put the key is broken on the back side of the unit is a swith that is y u can turn key in positions ....if there is a time damage often similar problems comming...
0helpful
1answer

I have a 2001 land rover that wont start. I just

The starter might be dragging.If you crank a motor too much with a low battery it damages the starter or you could just have a bad connection.Check both battery terminals are tight and check all earth connections.
1helpful
1answer

My 2001 landrover discovery 2 will not turn over. I have a new starter and new battery. All the power items work but it wont turn over. Can u help?

check to make sure all fuse and relays are good. check the crank position sensor an the map sensor, make sure your getting 12v at the battery
Not finding what you are looking for?

915 views

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...