2000 Chrysler Sebring Logo
Posted on Jun 12, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

95 lebaron AC wont work...still!

I have replaced the resistor, fuses, blower motor switch -and still no AC. the shop i took the car to couldnt find the problem and i have replaced everything as listed above except for the blower motor, which they said was working. i dont know what else there is to replace. does anyone have any diagrams that might be helpful in pinpointing the problem? thanks for ANY advice that may help.
~roasting in SC

Answer This Question
  • whiteplum236 Jun 12, 2009

    dealership was no help. told me it would be $300 just to find the problem, without even fixing it. im about to buy a car repair manual but im not sure if it will help me because i dont know what im looking for. im not very knowledgeable about cars/parts. sigh... i turned the AC switch on and -nothing. just an air pressure sigh when the defrost button is pushed. dont know what it could be as of yet.

×

1 Answer

Spud Howell

Level 2:

An expert who has achieved level 2 by getting 100 points
MVP:

An expert that got 5 achievements.
Hot-Shot:

An expert who has answered 20 questions.
Corporal:

An expert that has over 10 points.

  • Expert 66 Answers
  • Posted on Jun 12, 2009
Spud Howell
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points
MVP:

An expert that got 5 achievements.
Hot-Shot:

An expert who has answered 20 questions.
Corporal:

An expert that has over 10 points.

Joined: May 01, 2009
Answers
66
Questions
6
Helped
22419
Points
172

Try getting a diagram from a dealership maint. dept. Chilton manuals are good get them at most auto parts stores or on the web

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Blower motor
I'm showing a blower relay and a resistor used on models with manual ac control.
The blower motor is grounded and the fan switch provides power thru the resistor. So you have a 40amp blower fuse that handles high thru the relay, then a 30amp HVAC fuse that powers the blower thru the fan switch.
Do you not have power from the resistor to the blower motor on the purple wire ?
Read full answer
Jun 26, 2013 • 2003 GMC Envoy
1helpful
1answer

Ac/heater fan doesn't work
According to my wiring diagram, the blue and white wire from the blower motor gets power from the key switch. The fan switch and resistor grounds the motor.
No blower fuse is listed.
Read full answer
Feb 03, 2013 • 1988 Honda Accord 4 Door
0helpful
1answer

1995 GMC Sierra fan blower not working.
In the beginning you should check for voltage and ground.
The 50amp fuse marked AC powers the blower motor and the motor is grounded.
The high speed relay bypasses the resistor. So you should have power coming from the fuse and thru the high relay. Then the resistor for the other speeds gets power from the heat and ac control module which also controls the blend doors.
You may need a shop manual or repair book to get the diagrams.
Read full answer
Jan 12, 2013 • 1995 GMC Sierra C1500
0helpful
1answer

2001 f150 blower motor wont work
Are you getting power and ground at the blower motor ?
Are you getting power at the resistor ?
Read full answer
Jul 27, 2012 • Ford Cars & Trucks
0helpful
1answer

I have 2002 infinity I35 and the blower motor stop working ,I took out the blower motor to make sure was good. YES the blower motor still working .the only think I really don't know how to check is Blower...
WELL YOU HAVE TO USE A VOLT METER CONNECT ONE VOLT METER WIRES TO GOOD GROUND AND THE OTHER VOLT METER WIRES GOES TO EACH SWITCH SPEED.IF VOLT METER GET VOLTAGE A 1 OR 2 CONTROL SPEED RESISTOR BAD.IF RESISTOR BAD YOU WILL GET 1 OR 2 BLOWER MOTOR SPEEDS.IF BLOWER MOTOR WORKING.CHECK THE AC AND HEATER CONTROL SWITCH FUSE OR CHECK BLOWER MOTOR FUSE AND RELAY.IF ALL GOOD SO FAR CONTROL SWITCH ITSELF COULD BE FAULTY.
Read full answer
Nov 05, 2010 • Infiniti I35 Cars & Trucks
3helpful
4answers

Blower suddenly quit working
The recharge of your a/c system and this is unrelated, could be a bad blower motor or blower motor resistor, have you checked your blower motor fuse? If fuse good, check voltage at blower motor, sit under dash on passenger side, just below dash, you will be able to see it, will have two wire's going to it, only one will have voltage with switch on, if you have voltage replace it, not that hard of a job to do, shop repair time to remove and replace blower motor is .7 tenths of an hour, hope this was very helpful.
Read full answer
Jul 07, 2010 • 1998 Volkswagen Beetle
0helpful
2answers

My AC was first only working at the max setting now not at all
go for the reostat which is all in one with the blower motor ,expensive part though
Read full answer
Jun 03, 2010 • 2002 Pontiac Grand Prix
3helpful
3answers

Air conditioning and blower stopped working, all fuses checked good.Is there a common feed to these two circuits?
The answer is that there is dirt dust and fuzz built up in the brushes of the blower motor. Had to figure this one out myself. Remove glove box, carefully disassemble bottom of blower motor, remove brush cap and brushes clean up mess and reassemble. Not for a novice but if you're a thinker you can figure it out. Mine has worked every time since. The Pontiac guys had no clue wanted to replace motor.
Read full answer
May 21, 2010 • 2004 Pontiac Vibe
0helpful
2answers

Ac blower wont start. have checked blower and starts directly with 12 volts from batt
check the fuses, blower motor resistor and the fan control switch
Read full answer
Feb 25, 2010 • 2003 Chevrolet Suburban 1500
0helpful
1answer

95 Elantra. ac blower not working, but when switched to full there is current drain
Yes, there's a relay in the passenger compartment relay box. Power flows from 2 fuses; blower fuse 30A in the engine compartment relay box and fuse 12 10A in the dash fuse box. The 20A fuse goes to one side of the blower relay contacts. The other fuse goes to one side of the relay control coil. When you turn the blower switch on, it ground the control coil which moves the contacts and sends power to the motor. The motor speeds are controlled on the ground side of the circuit by the blower motor resistor. Which resistor provides ground depends on the speed switch setting you choose. But the whole system depends on ground G01. If that ground is bad or corroded, the blower won't work
Read full answer
Aug 03, 2017 • Hyundai Elantra Cars & Trucks
Not finding what you are looking for?

View Most Popular

2000 Sebring

  • Cars & Trucks

Related Question

Blower motor

  • 2003 GMC Envoy

Related Topics

119 views

Ask a Question

Usually answered in minutes!

Popular Questions

2012 chrysler 200 serpentine belt diagram

2007 Chrysler Sebring Sedan

My electronic throttle control warning light came

2007 Chrysler Sebring Sedan

COMO PONER LA CADENA DE

2007 Chrysler Sebring Sedan

CODES,P0442,P0455,P0456,P1684

2002 Chrysler Sebring

Car Won't Fully Shift into Park

2004 Chrysler Sebring

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...