2007 Ford Focus (3 Door) Hatchback Logo

Related Topics:

B
Bryan Posted on Mar 04, 2014
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Rough accelration 5 Spd manual, MTX75 In Nutrual, reving is fine sounds normal. Whne put into gear on the other hand its got a rough take off. I notice that ive slight fluid coming out of the seal of the p/s axle but cant find the part number.

1 Answer

john stanley

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

  • Ford Master 499 Answers
  • Posted on Mar 04, 2014
john stanley
Ford Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

Joined: Feb 10, 2014
Answers
499
Questions
0
Helped
95713
Points
1357

Check your trans fluid immediately , then get a clutch

5 Related Answers

Anonymous

  • 3533 Answers
  • Posted on Feb 13, 2009

SOURCE: rough idle

when was the last time you had a good tuneup sparkplugs,wires if needed and fuel filter and replace the drive belt and also make sure all of the vaccum lines are on and the one behind the throttle body

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Feb 18, 2009

SOURCE: ROugh idle

there are 2 things that usually cause this, one is a dirty intake idle control valve and the other is hard engine mounts, I would say that both most likely apply to your car. try cleaning the intake with the following procedure from Ford.
Here is the most common cause of surges and stalls and low idle rough idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Anonymous

  • 24 Answers
  • Posted on Feb 21, 2009

SOURCE: 1995 F-250 runs rough

Check exhaust compression. Remove the O2 sensors before the cataylatic converters and see if it improves. If it does then the cats are cloged and need to be replaced.

Anonymous

  • 3 Answers
  • Posted on May 07, 2009

SOURCE: 2000 f-250 running rough, overdrive light flashing

check for a loose ground coming off your computer...i had the same problem and ford had to change the computer...well it turned out to be a loose ground..

jaysonemanme

Jason Phillips

  • 500 Answers
  • Posted on May 20, 2009

SOURCE: rough idle in gear 1997 ford contour 4 cyl ohv

probably a dirty idle air control valve

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

2002 chevy truck 5 speed 1st,2nd an 3rd gear grinds or rough, 4th an 5th are fine

Either your syncro's are out or your clutch and throwout bearing need to be replaced. Normally higher gears will shipt easier. You need to chech for a grinding sound or howling when you engage the clutch.
0helpful
1answer

My 2001 Chrysler Town & Country idles fine in park and nuetral and sounds good while reving. When I put it in gear it runs rough. I have read a few things on line and saw to check the idle control...

Hi. Thanks for your question. For assistance on any sound issuerelated to gear on Chrysler Town you can visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams for better understanding. Good day!
1helpful
1answer

When i put car i revers it reves high then stalls. and in drive it reves up and down

Lack of power and a vehicle running rough can be caused by one of two very common problems. One is a leak in the air duct between the air filter and the throttle body. This will generally make the car also hard to start. The other is a leak from rubber hoses connecting the intake to the PCV valve at the crankcase causing a vacuum leak. This will normally cause the vehicle to rev when in park and when first put in gear. More serious problems such as a misfire from a bad coil pack or a blown head gasket can also cause the vehicle to lose power and run poorly but these are not as common.
0helpful
1answer

Lost power to engine

Check make sure all plugs are firing. Sounds like what my 93 Rodeo was doing-Idled okay but very rough when in gear. Turns out only 5 out of 6 plugs were firing due to a defective ignition module- 100 bucks later it works fine.

Hope this helps.
0helpful
1answer

Shifts rough in 1st gear and lose overdrive at times

on the older style blazers the fan clutches did fail and would often be misdiagnosed as shifting problems as the clutch engaged and disengaged.... also a hard 1-2 shift can be due to your vehicle storing a transmission fault code in the ecm... some transmission fault codes will put the transmission into a fail safe or limp mode in which it engages high line pressure .... this can cause your hard 1-2 shift and will feel normal most of the time other than that. high mileage on the transmission fluid may also require it to be flushed and have the filter kit replaced
0helpful
1answer

Sierra 3500HD rough idle

do a good tune up it is not the tranny . you might think about a good diagnostic test to make sure it is not a senser it is hard to say for me onless i could look the truck over my self . good luck
Not finding what you are looking for?

109 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...