Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Feb 27, 2014

P1764 Clutch solenoid valve

Locaion

1 Related Answer

Terry Corrow

johnny rebel

  • 10875 Answers
  • Posted on Jun 04, 2015

SOURCE: Direct clutch solenoid valve code p1764 infinity 06m45 I hear a thump when in reverse....gears don't switch

transmission failure,repair or replace

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

01 accord 2 codes p1751, and p1700

1700 is a generic code for many makes and models referring to a transmission issue.1751 is directed to the shift solenoid valve b. May be able to replace just that solenoid and be ok. Cheaper than a transmission.
1helpful
2answers

2009 Cayman S, has an intermittent problem where reverse will not engage. Code is P1764. PIWIS flow chart says see importer

P1764 OBD Trouble Code P1764 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.
P1764 OBD Trouble Code Repair : The sensors receive a 5 volt reference signal from the PCM. As pressure readings change, the sensor varies the voltage and the computer reads that to determine input. In the case of a broken wire, the sensor never sees the voltage and the computer assumes a major fault. So if you get this P1764 code, first check to make sure you're getting a good 5 volt reference signal at the sensor.
0helpful
1answer

I have a 2001 aurora and code p1860 p1860 came up what is this and how much to fix

P1860 All GM - TCC (transmission Torque Converter Clutch) PWM Solenoid Circuit Electrical.
P1860 Description The Torque Converter Clutch Pulse Width Modulation (TCC PWM) solenoid valve controls the fluid acting on the converter clutch valve. The converter clutch valve controls the TCC application and release. The solenoid attaches to the control valve body within the transmission. The solenoid receives ignition voltage through circuit 239. The Powertrain Control Module (PCM) controls the solenoid by providing a ground path on circuit 418. Current flows through the solenoid coil according to the duty cycle (percentage of ON and OFF time). The TCC PWM solenoid valve provides a smooth engagement of the torque converter clutch by operating during a duty cycle percent of ON time.
When is the code detected? When the PCM detects a continuous open, short to ground or short to power in the TCC PWM solenoid valve circuit, then DTC P1860 sets. DTC P1860 is a type B DTC.

Possible causes - Faulty Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid
- Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid harness is open or shorted
- Torque Converter Clutch Pulse Width Modulation (TCC PWM) Solenoid circuit poor electrical connection. Unless you have a factory manual and very good auto repair skills this is best left to an expert. It is a messy dirty job that requires removing the parts inside the transmission for testing..

0helpful
2answers

I have Honda Accord 2001and I put the scanner this Code come out p1768 what this means

Possible causes
- Clutch Pressure Control Solenoid Valve harness is open or shorted
- Clutch Pressure Control Solenoid Valve circuit poor electrical connection
- Faulty Clutch Pressure Control Solenoid Valve

Has to do with the solenoid or wiring to the solenoid inside the transmission. You should have the problem addressed at a transmission shop.
0helpful
1answer

Nissan 350 z p1762 code

P1762 Nissan - Direct Clutch Solenoid Valve Possible causes
- Faulty Direct Clutch Solenoid Valve
- Direct Clutch Solenoid Valve harness is open or shorted
- Direct Clutch Solenoid Valve circuit poor electrical connection
P1762 Nissan Description
Direct clutch solenoid valve is controlled by the Transmission Control Module (TCM) in response to signals sent from the PNP switch, vehicle speed sensor and accelerator pedal position sensor (throttle position sensor). Gears will then be shifted to the optimum position.
0helpful
1answer
2helpful
1answer

Codes po740, po743 ? po753 all at once. Where should i begin for repairs?

You must do the diagnostics for each code.
Here are the possibilitesP0740 DODGE - Torque Converter Clutch Circuitxicon.jpghttp://engine-codes.com/p0740_dodge.htmlForum CodePossible causes- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
P0743 DODGE - Torque Converter Clutch Solenoid Circuitxicon.jpghttp://engine-codes.com/p0743_dodge.htmlForum CodePossible causes- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid

P0753 DODGEP0753 DODGE - 3-4 Shift Solenoid Relayxicon.jpghttp://engine-codes.com/p0753_dodge.htmlForum CodePossible causes- Faulty shift solenoid valve
- Shift solenoid valve harness or connectors
- Shift solenoid valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid
1helpful
2answers

P0741 code

P0741 MITSUBISHI - Torque Converter Clutch System Malfunctionxicon.jpghttp://engine-codes.com/p0741_mitsubishi.htmlForum CodePossible causes- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Transmission internal mechanical problem
1helpful
1answer

1998 saab 960 s po743

P0743 - Torque Converter Clutch Circuit Electrical
Symptoms - Engine Light ON (or Service Engine Soon Warning Light) Possible causes - Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid
Tech notes This is an electrical problem code. Could be a problem to the harness to the TCC solenoid, the TCC solenoid connector or the TCC solenoid it self.
Not finding what you are looking for?

156 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...