There SHOULD BE AT LEAST TWO SCREWS HOLDING THE LICENCE PLATE LENS IN PLACE .REMOVE THE SCREWS AND PULLTHE BULBS OUT,THEN PUT (NEW BULBS)IN PUT IT BACK TOGETHER,MAKE SURE THE NEW BULBS WORK BEFORE PUTTING IT BACK TOGETHER
SOURCE: My spark plugs in my
YOU NEED LONG SPARK PLUG SOCKET. NEED A 3/8 INCH RATCHET WRENCH.YOU NEED EXTENSION.YOU NEED SPARK GAUGE YOU NEED A TORQUE WRENCH. NOT MANDATORY JUST DONT OVER TIGHTEN SPARK PLUGS STRIP ALUMINUM THREADS WAIT UNTIL ENGINE COOL TO KEEP FROM WARPING THE HEADS. SPARK PLUGS LOCATION ON TOP OF CYLINDER HEADS.TO GET TO SPARK PLUGS THE COILS ON TOP EACH SPARK PLUG.HAS TO BE REMOVED BY REMOVING SMALL SCREW.THAT HOLD COILS DOWN.AND CHANGE ONE SPARK PLUG AT A TIME SO YOU WONT GET THEM MIXED UP.GAP PLUGS AT 0.028 - 0.031
SOURCE: Can not find the Cabin Air Filter on my 2004
This one is easy! Pull out glove box and there it is!
SOURCE: Timing Belt for 2004 Mitsubishi Endeavor
Yes, I would replace it according to the owner's manual. Could be very expensive if it breaks.
Charlie
SOURCE: Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)
IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE
490 views
Usually answered in minutes!
×