When driving the jeep lacks power and stalls, have to pull over to get it to start
SOURCE: where is the pcm on 1997 jeep grand cherokee 6 cyl?
I don't think the PCM is your problem, is the check engine light on? It could be you idle air control motor this is located on the throttle body, but because this happens while driving I am thinking you will need to replace your crank shaft position sensor it is located on the transmissinon bell housing it is very hard to replace without the correct tools. If the check engine light is on take it to a local auto parts store and ask if they can check the check engine codes for you they usally will do this for free.
SOURCE: 1993 jeep grand cherokee, choking, pulling then stalled,
Check:
- Fresh Air Intake Hose:
Clogged or Damaged FreshAir Intake Hose.
- Carburetor:
Worn, Faulty or Damaged Carburetor.
- Mass Air Flow Sensor:
Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit.
- EGR Valve:
EGR Valve Sticking Open/Leaking.
- Idle Air Control Valve:
IAC Valve Sticking or Faulty.
Good luck.
SOURCE: 2004 Jeep Grand Cherokee. Keeps stalling, engine
P0505 means the whole Idle Control system, not only the IAM. Check all related sensors (i.e. crankshaft sensor). Check with a voltmeter direct at the connector of the IAM if you get any signal. Remove the IAM from the TB, connect him, let someone switch your ignition key to ON. The IAM need to drive in/out for a short time to find the right position. Hold the IAM near a hard part, that they cant drive out completely! If IAM works fine, check the fuel pressure, check and clean your TB ( if not done yet). If that doesn't work, come back again please
SOURCE: My 95 Jeep Grand Cherokee V8 keeps stalling when I
hi, this problem to me sounds like the oxygen sensor needs replacing as when the vehicle is first started or from cold you will find it starts with no problems but once its up to temperature then you start getting problems.
This is due to the oxygen sensor(lambda sensor as its proper name) not working when the engine is cold it only starts working when the engine is up to temp so if this is when your getting the problems then this is what i would look at first.
Let me know how you get on or if you need further assistance ok
SOURCE: 1999 Jeep Grand Cherokee stalls immediately after
check intake manifold air temp sensor and engine coolant sensor...one may be out of range but not enough to turn on dash light. tests and specs can be found in chiltons or haynes, test is done with digital multi-meter.
146 views
Usually answered in minutes!
Hi delynn williams, I want to help you with your problem, but I need more information from you. Can you please add details in the comment box?we have changed the cami position sesnsor and the coip pack and does the same thing. jeep will driving keeps cutting out, and have to pull over and try to restart it.
WE have changed the the cdoip pack and the cami position sensor and still keeps cutting out. have to pull jeep over and its quits and then try to restart it
×