Today i was driving heard a clunk and then it would not drive in 2 wheel. it drives okay in four high and four low? today I was driving like normal, heard a clunk, and the jeep would not drive in two wheel any longer. when I put it into four wheel it drives. it is an automatic four wheel drive.
SOURCE: jeep stuck in low four wheel drive
Put the transmission in neutral, emergency brake off, foot off the brake pedal, now try shifting out of 4 wheel drive low. If that doesn't work, drive forward, and again do the above, trans. in neutral, roll to a stop, foot off brake, try to disengage. What you're probably experiencing is called drive shaft 'wind up', and it is very difficult to disengage, but do the above and it should shift out of 4 low. countrycurt0
SOURCE: 4x4 wont work in a 97 jeep
The only Solution to this is 1 of 2 Things ! The Shifter Linkage is Off of the Transfer Case 2 The Transfer Case is Shelled out and needs to be Rebuilt. Check underneath on the Transfer case for any Noises when in 4X4 and Check the Linkages. Please Rate my Response, I need all the Help That I can Get! Thanks!
SOURCE: Jeep Wrangler 1998 Sport Four Wheel Drive stuck in high
Try putting the car in neutral first. Try going in reverse while shifting out of 4wd.
SOURCE: 1999 jeep grand cherokee all time four wheel drive will not engage
Sounds like the splines on your transfer case gear are ground down
SOURCE: 2004 jeep liberty stuck in 4 wheel drive low -
a reluctant transfer case can sometimes be coaxed by shifting into reverse, backing up 10 feet, and then back to forward.
355 views
Usually answered in minutes!
×