2008 Pontiac Montana SV6. Tried to start this morning. Lights are on and horn going off when trying to start. Battery is at 10.4 Volts. It was very cold last night, and van was plugged in. Not sure if this is a battery or starter issue.
SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
SOURCE: The battery on my 2003 pontiac montana isnt
Depending on how old the battery is can determine if it needs to be changed or you have another problem that is not letting the Van start. Take the battery out and charge it slow for 8 to 12 hours, then take it to a parts store that will load test it and determine if it is ok or defective. The parts store will sell you the proper battery for your vehicle.
SOURCE: 1998 Pontiac transport van wont start:
Well you hit all the major ones, could be crank position sensor, ignition module, a bad coil pack (it should have 3), you need to check that you have spark to each plug while the engine is turning over (!!!be careful as this will hurt if you get shocked!!!), this will rule out coil packs. if you have no spark to any plug your looking at a bad ingnition module (which is what the coil packs bolt to). Hope this gets you on the right track!
SOURCE: 2005 montana sv6 remote start
Some vehicles come with a immobilizer system. Although a key works fine if it picks up interference from other electronic devices, even other keys in some cases, it will disable the vehicle from starting.
Something you can try.
Take the key, by itself, ( remove any other objects that may interefer ), put it in the ignition and turn to the ON position for 5 seconds, then turn the key to the OFF position for 5 seconds, repeat steps 1 and 2, and then try to start the car again.
I really hope this will work for you.
SOURCE: changed starter on 01 montana now van won,t start
2001 Pontiac Montana, Been in and out of shop a year now. Started when I had a starter replace. It will crank multiple times for a day or two. Not getting any bad codes from computer. Have had every sensor replaced. Let it set for a few days it will crank for a day...the next moring it will not crank for days. Wiring has been run and checked, fuel pump comes on, started is engageing fine. One mechanic said it was not getting fire, he replaced a unit on the back of the engine that usualy goes bad...still wont crank...the next day it cranks. i am about to redy to give up.....but it has low miles. need some help.
2,251 views
Usually answered in minutes!
×