Brake/ABS/Traction lights on plus no AC

VWVortex.com - Traction control light flashing, losing power?

forums.vwvortex.com > ... > VW Model-Specific Forums > Golf IV R32

May 20, 2011 - 25 posts - ‎14 authors
So last night I was driving home, went around a pretty sharp turn and my traction control light started flashing for about 5 seconds, then went ... Traction control and ABS light issues
15 posts
Feb 22, 2010
E-Brake warning light stays on -- help
22 posts
Sep 27, 2004
More results from forums.vwvortex.com

Abs and Esp Lights on!? - TDIClub Forums

https://forums.tdiclub.com/showthread.php?t=333091

Oct 18, 2011 - VW MKV-A5 Golf/Jettas. ... Suddenly i noticed that the ABS and the ESP light on the dashboard was on. ... Fuel Economy: 47+ Avg (Passat DSG) 50 Avg (SE Manual) Warm Weather. ... I might suggest that your ABS and traction controlpick up their information ... A bent ring or bad sensor will set both errors. On-and off grinding on hard left and traction control light ...
Nov 3, 2015
ABS brakes activating when slowing down - wheel speed indications ...
Jan 20, 2012
More results from forums.tdiclub.com

Electronic Stability Control - Auto Diagnosis Repair Help

PRE-DIAGNOSTIC INSPECTIONBefore diagnosing ABS/TCS, perform a comprehensive visual inspection of system as follows.Check ABS/TCS wiring harness connectors for looseness. Check harness routing; pay particular attention to wheel speed sensor wiring harness routing. Check fuses No. 1D, 5B and 6B in instrument panel fuse block. Check fuses No. 1 and 2 in underhood fuse block. Check brake fluid level in master cylinder reservoir. Check brake fluid level in Pressure Modulator Valve (PMV) assembly reservoir. Ensure parking brake is fully released. Ensure parking brake switch is functioning properly. Always perform ABS/TCS system functional check before using DIAGNOSTIC CODE CHARTSThe EBCM/EBTCM has self-diagnostic capability, which can detect system failures. Fault codes stored by EBCM/EBTCM can be displayed using Tech 1 scan tester. There are no provisions for flash code diagnostics.Begin ABS/TCS diagnosis with PRE-DIAGNOSTIC INSPECTION procedure. If failures are found during pre-diagnostic inspection, perform necessary repairs, and proceed with ABS/TCS FUNCTIONAL CHECK. See Fig. 5 .If no failures are found during pre-diagnostic inspection, go to ABS/TCS FUNCTIONAL CHECK. See Fig. 5 . The ABS/TCS FUNCTIONAL CHECK will either indicate ABS/TCS is functioning properly or direct technician to various diagnostic procedures such as diagnostic charts, symptom diagnosis or BRAKE warning light diagnosis.CHART D - TRACTION OFF WARNING LIGHT ON CONTINUOUSLY & NO DTC SET (BUICK WITH UH8 OR U2A INSTRUMENT CLUSTER)Circuit DescriptionWhen ignition switch is first turned to RUN position, EBTCM goes through a self-test, which lasts 2-4 seconds. During self-test, EBTCM commands TRACTION OFF indicator warning light on. Powertrain Control Module (PCM) can also command EBTCM to set a Code 75 which will illuminate TRACTION OFF indicator.Traction control switch is located either on instrument panel center trim plate or driver's front door trim panel. Switch allows driver to select traction control mode (on/off). When traction control system is turned off, TRACTION OFF warning light comes on.EBTCM monitors transaxle temperature through

It is safe to drive. You need a scan tool to get a code out of it. Could be as simple as a wheel speed sensor going bad. All of these lights will work together normally. The traction control uses the ABS to gain traction, and the Brake Assist System is part of the stability control. Also uses the ABS.

ur blake light switch needs replaced I had same problem.

If brake pedal is chattering or pulsating it is most likely because you need either front or rear rotors, or both. They are rusted or out of round. If there is something wrong with either your abs or traction control,the abs or traction control light will come on & stay on. As soon as these lights come on, it automatically disables abs or traction control. If you would like to take out fuse that disables abs or traction control circuits, it will leave the lights on.You just wont have their functions. If by some strange condition your chattering goes away, then there is indeed something wrong with your abs or traction control.Fuses are labeled abs or traction either under hood or in your fuse panel in car.

chek the brake fliud level. if low light will set light and abs wont work.

Hi ,
Take it back and tell them to code it properly! F.O.C.

you'll have to have it diagnosed at a repair shop to pinpoint the source. sorry, but thats how they make them. you could buy your own but it'll cost about 200$

ABS and traction control really are only for panic stops and if your tires slip on wet surface's and yes each tire has a sensor on it. However if the brake light comes on this has nothing to do with the ABS or traction control lights. It's not a parking brake light. This light tells you, you have a serious brake problem.

ok your problem is that your brakes are under force you shold get new brake pads ok