SOURCE: 1999 Honda Accord Coupe
See an example
DISASSEMBLY
1.
Remove the suction pipe and the O-ring from the oil pump.
2.
Remove the rear cover with the gasket and pins.
3.
Remove the cam ring.
4.
Remove the rotor and vanes.
5.
Remove the front side plate.
6.
Remove the inner and outer O-ring.
7.
Remove the spring.
When assembling, use a new gasket and O-ring.
8.
Remove the pulley nut with the spring washer.
9.
Pull off the pulley and the woodruff key.
10.
Remove the snap ring using snap ring pliers.
11.
Drive out the pulley shaft with the bearing. If necessary, use plastic hammer
SOURCE: How to change the HEPA cabin filter in a 2006 Honda Civic
Open the glove box and there are push out tabs on the left and right side pop them out. Now watch it because you are about to dump the contents of your glove box on the floor. let the box hang freely from the lower hinge and look in the back. You will see a white panel that pulls out the panel has a tray attached with the filter element in it remove old element and replace with new 20ish bucks at the parts store lots more at the dealer. re-install filter tray and reverse your removal steps to re-install. Recommended approx 15k or annually
SOURCE: I'm trying to remove the
4. Install in the reverse order of removal, and make sure there are no air leaks.
SOURCE: Bumper cover removal
It is a little more complicated than that. There are two nuts below the headlight assemblies in the engine compartment. You will need to remove the battery and overflow bottle to get at the one on the passenger side. Remove the turn signals in the bumper, then there are 2 or 3 bolts holding a mounting bracket behind the each of the turn signals. There are a number of bolts with washer heads and reatiners on the underside of the bumper as the previous responder indicated.
SOURCE: 2005 Honda Accord Front Bumper cover replacement
easy there is a screw on both sides were bumper and fender meet just pop back fender liner its a phillips head. Then pop hood remove clips on black trim infont of radiator. Underside where bumper goes under car remove those clips and 10mm bolts after all is removed bumper just pulls off ...... may have to give it a hard **** a few times but it will come off. Should only take 15-20min to remove if its your first time
478 views
Usually answered in minutes!
×