When I start my odyssey it starts surging. I found a small rubber hose on the right side of the engine, but don't know where the other end of the hose goes....Help

WHAT COUNTY???????????????????????????????????
hot engine, cold or both?/// a key question
WHAT ENGINE: ( usa list , ONLY)
2.2 L F22B I4
2.2 L F22B6 I4
2.3 L F23A I4 2.3 L F23A7 I4
the fsm covers this. hose thing.... all hose can be followed,
unless its axle vents on 4wd cars. (they go no where, special)
is surging the only symtom.?
no engine stalls.?
lack of power in any gear or hills.
no misfiring?
no flooding.?
starts easy/?

ok what is surge, that it really is idle controls bad or out of comtrol
1: idle controls bad. (isc dead?)
2: or engine is running way too lean, and ISC cant keep a grip on idle.

easy huh?
and #3 misfiring so bad the idle controls fail.
are all fuses good?
is the CEL lamp glowing , then goes out running engine.
no , the scan it. or do the flash DTC codes trick.

a good tech ,first finds out if the engine holds closed loop status
hot. at idle, if not, he fixes that first.
as he/she knows that idle is the last thing to work right, in EFI.

one other way to get surge is air leaks (aka. vacuum leaks)
if the engine (unsaid option) is MAP based, it will race fast
with any vacuum leak, and it dont take much of a leak
to make the ISC idle controller go nuts.

so repost , hot/cold both questions
and actual RPM numbers. we need numbers
is the dash Tachometer missing. ????
and what engines in car.

all lean engines surge.
all ISC systems can surge if out of control , not all do this. just 1/2
if the ISC surges, it means its trying hard to gain back control.
this is called a software servo loop.
The ECU is programmed to hold rpm near say 800 RPM hot.
and is very digressive in that role.
I have a 91 car that will surge, with any vacuum leaks.
(by design) depends on which engine.