Hi, P0151 code and the rest code refers to the first oxygen sensor on BANK 1. P0151 means the O2 oxygen sensor's voltage remained low for longer than 2 minutes. This, is interpreted by the ECM as a low voltage condition and sets the MIL. Bank 2 Sensor 1 is located in front of the catalytic converter.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Question edited for clarity. It is P-Zero 0, not P-oh O.
Please always include 'year make model' first 3 words, or it it is difficult to answer and some vehicles are slightly different or more precise and will show known issues.
• DTC P0171 Fuel Trim System Lean Bank 1
• DTC P0174 Fuel Trim System Lean Bank 2
.
The engine control module (ECM) controls the air/fuel metering system in order to provide the best possible combination of driveability, fuel economy, and emission control. Fuel delivery is controlled differently during Open and Closed Loop. During Open Loop, the ECM determines fuel delivery based on sensor signals without oxygen sensor (O2S) input. During Closed Loop, the O2S inputs are added and used by the ECM to calculate short and long term fuel trim (FT) fuel delivery adjustments. If the O2S indicates a lean condition, FT values will be above 0 percent. If the O2S indicate a rich condition, FT values will be below 0 percent. Short term FT values change rapidly in response to the heated oxygen sensor (HO2S) voltage signals. Long term FT makes coarse adjustments in order to maintain an air/fuel ratio of 14.7:1. If the ECM detects an excessively lean condition, DTC P0171 or P0174 sets.
Diagnostic Aids
• Excessive resistance in the fuel injector ignition 1 voltage circuit or the fuel injector control circuit may cause the following symptoms:
- Lean condition
- Misfire
- Rough idle
• The system will go lean if an injector is not suppling enough fuel.
• A lean condition could be present during high fuel demand.
• A malfunctioning MAF sensor can cause this DTC to set. Refer to DTC P0101 .
• Review the Failure Records with a scan. If an intermittent condition is suspected, refer to Intermittent Conditions .
DTC Descriptors
This diagnostic procedure supports the following DTCs:
• DTC P0420 Catalyst System Low Efficiency Bank 1
• DTC P0430 Catalyst System Low Efficiency Bank 2
This code could mean the catalytic converter on that bank has failed .
my carnival was loosing power specially at signal when i start to move the stopped verhicle.i just increase the excelerator and fix it at 1.now its smooth.
All of the codes relate to emissions
Catalytic converter, oxygen sensor and evap purge solenoid.I would do the following.Check the fuel cap or replace it.Clear the codes with an OB2 reader and see if they return
probably changed the wrong sensors
The units you should have replaced are the heated oxygen sensors in the exhaust manifold before the cat converters (HO2S)
oxygen sensors(O2S ) are after the cat converters codes p 0171,0174 are lean mixture codes and p 150,p0154 are HO2S sensor faults
as the Ho2s sensors read the composition of the exhaust gas and report to the ECM to adjust the fuel settings then t faulty HO2S sensors will result in a lean or rich reading resulting in the other codes
×