Cars & Trucks Logo

Related Topics:

g
george nixon Posted on Feb 13, 2014

Bonnet problem on my 406 coupe the lever clicks but wont release the bonnet its a 2002

Lever inside car works but wont release my bonnet

5 Related Answers

germcelchar

Charles McElchar

  • 389 Answers
  • Posted on Aug 11, 2009

SOURCE: problem with windscreen washers on 1998 peugeot 406

The washer pipe comming from the tank to the jets is probably folding over of touching something between the bonnet and the check the pipe is in place where it folds with the going up and down

Ad

Anonymous

  • 1 Answer
  • Posted on Feb 16, 2010

SOURCE: Peugeot 406 Coupe v6 . Speedometer Problem

i had the same problem, in behind the glove box there is a black cigarette sized box, this was faults on my 406 coupe and the speedo didn't owrk, or suddenly it shot from 0 while dribing up to 30 or what ever my speed was, it also wrecked my powersteering rack trying to drive it, as it made terrible noises as its speed sensitive. you local peugeot dealer will be able ot get you one. i can't remember how much it cost, sorry.

Anonymous

  • 1874 Answers
  • Posted on Nov 16, 2010

SOURCE: how to change the spark plugs on peugeot 406 v6 3l

1. Spark plugs removal

1.1. Front cylinder bank spark plugs removal:
1.1.1. Disconnect the battery from car terminals.
1.1.2. Remove the engine plastic cover.
1.1.3. Disconnect the ignition coils electrical supply cable and all three coils connectors.
1.1.4. Remove all three ignition coils screws.
1.1.5. Remove all three ignition coils out from cylinder head.
1.1.6. Remove all three spark plugs out from cylinder head (straight forward).

1.2. Back cylinder head bank spark plugs removal:
1.2.1. Remove the inlet manifold out from cylinder head.
1.2.2. Disconnect all three ignition coils connectors.
1.2.3. Remove all three ignition coils screws.
1.2.4. Remove all three ignition coils out from cylinder head.
1.2.5. Remove all three spark plugs out from cylinder head (straight forward).

2. Spark plugs installation

2.1. Refit all in reverse order.
2.2. Spark plugs tightening torque = 2,8 +/- 0,3 daN.m
2.3. Ignition coils tightening torque = 0,8 +/- 0,2 daN.m

Testimonial: "cheers"

cy schousboe

  • 2002 Answers
  • Posted on May 09, 2011

SOURCE: hi my mums got a

It sounds like the cable is dry. With the car turned off spray a lubricant like WD-40 on the exposed end of the cable and work it back and forth as you do. It should free up. It wouldn't hurt to spray the throttle lever either. Hope this helps.

johnf1aresti

ARESTI

  • 1152 Answers
  • Posted on Sep 09, 2012

SOURCE: how do i get a car owner's manual for peugeot 406 coupe

why don't you try to get a Haynes Manual for the peugeot 406? It has more advises and mechanical and electrical directions

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Is there another way to open the bonnet on a fiat coupe 20v, if the lever in side the car does not work, please

Can you can get to the wire inside the vehicle? Try pulling it with a good set of grips or pliers. If not you will have to use a large flat blade screwdriver through the front grille to try and 'trip' the release lever at the actual latch. Try the attached YouTube link. It should work with the grille in position. Fiat Coupe Bonnet Release
1helpful
1answer

Where is the release catch situated on a 54 plate hyandai coupe ?

in the drivers side its a grey square thing near the bottom near the door frame just above the gas pedal and the over one is under the bonnet in the middle you have lift and feel for a little lever and lift the bonnet and its got a little arm at the side of the wing to put in bonnet to hold it up and make sure you keep the enjectors clean I had the coupe I loved iv got a cdx now 2005 if you more help [email protected]
0helpful
1answer

Im having trouble trying to open the bonnet on my territory, the lever inside the car works, but it doesn't free the latch mechanism inside the bonnet, the wire isn't broken either.???

try coming up in front of the radiator with a long lever and release the bonnet latch
when you have the bonnet up then adjust the cable and tighten up the cable clamp
1helpful
1answer

Carnt open bonnet on my audi a4 2002 model, the realease pull works but doesent seem to release fully only a couple inch! any idea's anyone regards mike

There is another lever at the front of the car that you need to release too. This is to prevent the hood flying open if you accidentally pull the release while driving. After you release the latch inside the car, go to the front of the car, near the Audi rings, in the center of the grill there is a small black tab that pops out when the internal hood release is pulled. Pull up on it and the hood will open. Let us know if that works.
0helpful
1answer

Front bonnet catch wont release fully,i pull lever from inside and it releases bonnet just a couple inch, then when try to lift bonnet up it wont open. regards mike, and thanks in advance

There is another lever at the front of the car that you need to release too. This is to prevent the hood flying open if you accidentally pull the release while driving. After you release the latch inside the car, go to the front of the car, near the Audi rings in the center of the grill there is a small black tab that pops out. Pull up on it and the hood will open. Let us know if that worked.
0helpful
1answer

2002 C-Class Mercedes driver-side hood latch stuck and will not release. Cable is not broken...passenger-side and middle opens perfectly fine. How do I fix this problem?

i have the same problem on my Merc C200k coupe 2002 i have been told you have to go through the grill but i cant work out how to get the gill off with out opening the bonnet lol
0helpful
2answers

Bonnet stuck down

If the inside latch won't work, you'll have to reach up from underneath the hood to pull the lever over to open. Usually a flatblade screwdriver will help. The latch lever has to move towards driver's side to open.
1helpful
1answer

S864XOP Ford Fiesta Zetec cannot open bonnet - when I pull release lever under steering wheel bonnet does not release completely (when push down on bonnet I can hear the catch click closed). Any...

get assistant to push down on bonnet whilst you pull the lever ,then once you pull back the lever and hold it back they try to lift it so it clicks up a bit then you open it by the safety catch
1helpful
1answer

Bonnet wont lock

Bonnet is held separately: mechanisms front left and front right. Suggest one latch only is operating/secure in your case; non-secured side will float and sit slightly proud of front wing line. Unscrew mechanism, detatch release cable and free-up "spring and pawl"; refit etc.
2helpful
2answers

Cant open bonnet on my vauxhall astra 1.4

It sound like it i out of adjustment. I had this same thing occur n my car. Ask an assistant to pull the release lever inside the car all the way, then try to open the bonnet while they are pulling on the lever.
Not finding what you are looking for?

127 views

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...