Have trouble code p1782 - 1999 Mitsubishi Eclipse

https://www.engine-codes.com/p1782.html P1782 2 4 OD Pressure Switch Circuit

Low Battery Voltage Low transmission fluid level Dirty transmission fluid Faulty 2/4-OD Pressure Switch 2/4-OD Pressure switch poor electrical connection 2/4-OD Pressure switch circuit is open or shorted

Read more: https://www.engine-codes.com/p1782.html

I would start with the p1782 the clear the codes. If the check engine light pops back on with the codes, then start replacing them.

let it dry out dodges were famous for getting the distributer wet and it running like crap. you have a spark module i beleive if you got some of your electronics on the motor wet they need to dry

P1782 is 2-4 pressure sense circuit and po700 is internal trans controller. take to a shop .

2000 caravan with codes p1782 and po700,this is transmission codes, i will tell you this, with out a good scan tool to check the problem correctly you will be just throwing money at it.

this may be due to a bad shift solenoid pack or wiring or internal transmission problems. sorry to say but these transmission are junk.
I would have a transmission shop or dealer check it, maybe the dealer unless you know a good transmission shop that will not try to sell you a rebuilt ******.

Hi, the code P1782 means that 2-4 pressure switch sense circuit FAILURE. It basically means that the transmission solenoid pack needs to be replaced.

p0700 means there is a code stored in the tcm ( transmission control module). P1782 is 2-4 pressure switch sensor sense. This could be just a bad connection or a bad solenoid pack. Many times itis the beginning of the end.

inside trany on valve body.

P0732 Gear 2 Incorrect ratio
P1782 P/ES Circuit Out Of Self Test Range
P1787 2-1 Downshift Error
P0700 Transmission Control System (MIL Request) Malfunction

Here is the deal, u have some serious transmission related faults, in order to sort this out u will need to take this to the dealer, allot of testing is required to get to the bottom of this, if I had to guess I would say the trans is going to have to be overhauled.

The code P1782 MEANS 2-4 pressure switch sense circuit FAILURE. Basically means that the transmission solenoid pack needs to be replaced. Not a hard job