Front turn signal replacement - 2004 Toyota Camry Solara

What fuse are you pulling ?

Hazard Lamps
The hazard warning switch is part of the turn signal switch. The turn signal switch receives battery voltage at all times through the HAZARD SWITCH Fuse. When the hazard switch is placed in the HAZARD position, battery voltage is applied to the hazard lamp/turn signal lamp flasher. The hazard lamp/turn signal lamp flasher sends a turn signal flasher signal to the turn signal switch. The turn signal switch provides all of the turn lamps and turn indicators with the turn signal flasher signal, simultaneously flashing them on and off.

Turn Signal Lamps
The front turn signal lamps are made up of the front park/turn signal lamps and rear turn signal lamps. The front turn signal lamps flash with the rear turn signal lamps when a turn is initiated using the turn signal/multifunction lever. The turn signals will operate only with the ignition switch in the RUN position and will not operate during hazard flasher operation.
When the ignition is turned to the RUN position, battery voltage is supplied to the TURN SIGNAL Fuse. Battery voltage is then applied through the turn signal fuse circuit to the turn signal switch. When the turn signal switch is placed in the LH or RH position, voltage is supplied to the hazard lamp/turn signal lamp flasher. The hazard lamp/turn signal lamp flasher supplies a turn signal flasher signal to the turn signal switch. With the turn signal switch in the LH or RH position the corresponding turn signal indicator, rear turn signal, and front turn signal receive the turn signal switch signal and will flash. The front turn signals receive the turn signal switch signal from the turn signal switch via the BCM. The turn lamps are permanently grounded.

Replace the turn signal switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt.

try changing the signal flasher. note the e-flasher looks the same. when you find a flasher turn on the e-flasher so you know you have found the signal flasher. they are usually in the same general area.

Replace the bulb

I would change out the turn signal bulb on the right front. A blown bulb can cause the fast flash issue. The signals staying on is not related to the bulb being blown. That is most likely a problem with the multifunction switch, the knob you use to signal.

Check for power at the light socket aswell as grounds

Sounds like you need to replace the drivers brake/tail light.

check once more the front turn bulbs, connections, fuse if front and rear have a separate one. Once you connect the front turn signal, blinking frequency should normalize.

YOU HAVE TO THE FRONT HEADLIGHT HOUSING TO REPLACE THE TURN SIGNAL BULB.

1.Remove front & Rear turn signal Bulbs.
2.Replace Fuse.
3.Signal on.
4.Fix rear Signal Bulb.
5.Fix Front Signal Bulb.
7.If your Fuse blown.
8.Defect is There.

Here you go, removal & installation of:

Front Parking/Turn Signal Lights:

• Remove the screws from the the lens and separate the lens from the bezel
• Remove the screws from the turn signal housing and pull it out
• Turn the bulb socket CCW 1/3 turn and remove it
• Installation is the reverse of this procedure

Side (Front) Marker Lights:

• Remove the screws from the marker lens
  
• Separate the lens from the headlight
• Pull the bulb from the back of the lens
• Installation is the reverse of this procedure

Hope this helps

Mike