Ignition stuck on lock

using only electronic key or the metal key.(feature)
got park assist option?
a no key slot ignition, fails we scant the PCM for cause.

the steering is first. so wheels against curb or hard rock>?
front tires are free of objects?
to unluck it , try both key car came with new
and grab the wheel and move it CCW/CW roughly to free the key.
shifter is in park I guess. try Neutral? step brake
release hand brake, and shift to N
then unlock wheel. this answer is flat ground answer only

the steps are here
Check that the parking brake is set.
Check that the shift lever is set in P.
Sit in the driver's seat and firmly depress the brake pedal.
The "ENGINE START STOP" switch indicator turns green.
Pressthe"ENGINESTART
STOP" switch
if steering lock fails the books states

The "ENGINE START STOP" switch indica-
tor will flash in green and a message will be
shown on the multi-information display. Press
the "ENGINE START STOP" switch again
while turning the steering wheel left and right!!
read page 137

https://assets.sia.toyota.com/publications/en/om-s/OM53839U/pdf/OM53839U.pdf

There may be to much pressure on the steering wheel lock for it to go into the off position. put the parking brake on. put the shifter in neutral gently turn the steering wheel in the opposite direction of where the wheels are pointed and try turning the key to the off position. Good Luck

the ignition module (ignition switch on top of the steering column) normally doesn't get stuck.

things you can try:
steering wheel lock: (the pin gets a "burr" on it and locks everything up) wiggle steering wheel back and forth while trying to turn key.

transmission lock (parking on an incline will jam up the interlock)
push the shifter farther into park while trying to turn the key, or wiggle shifter

some of these electric interlocks require the brake pedal stepped on for releasing..have you tried that? along with shifting fully into park a few times?

No.
It could be a damaged lock cylinder, or the ignition switch.
You can disconnect the switch to see if the lock will move.

Make sure that the shifter is fully engaged in park and that the steering wheel is in the locked position. Also you can check to make sure that there isn't a small lever on the steering column that you need to push to release the key. Lastly you could try to step on the brake put the car in neutral and put the key in the off position and then gently pull out.

I have a 2011 Hyundai Veracruz and for no reason my steering wheel locked in position and the key would not turn. I tried everything for over an hour and then thought about disconnecting the battery to let all the electronics reset. I prayed about the situation and had other things to do so I left the battery disconnected for about an hour and when I returned connected the battery and magically (or a God answered prayer) the problem was solved steering wheel turned, key turned and engine started.

I just had this problem w/ a 2007 xc70 try this: http://www.volvoxc.com/forums/showthread.php?16222-Step-by-step-to-temporarily-mobilize-a-paralyzed-quot-stuck-key-quot-broken-switch-condition&highlight=ignition%20lock

Try turning the key while jerking the wheel left and right and depressing the brake pedal. If that won't work try another key.

Hi, what you need to do is put the key in the ignition then grab hold of the steering wheel then whilst trying to turn the key you need to turn the steering wheel to the left or right it may be a bit stiff but once its moved it should free the lock, so try turning the wheel to the left and right as hard as you can whilst turning the key doing this should free the steering lock and get it started.

also try putting the key in the ignition the other way round and then give it a try.

let me know if you need further assistance ok

plz rate this solution as i have a whole page of unrated posts, thanks