SOURCE: cv joint replacement
Remove the tire and tighten 2 lugnuts onto the brake rotor. remove the axle nut in center of the brake rotor and drive the axle out of the spindle. If the ball joint is original, you have to grind out the rivets on the lower control arm. Remove and replace the ball joint with the hardware included with the ball joint. Next, pry-unsnap the axle end from the transaxle with a prybay and drive-snap in the new axle shaft into the transaxle. reverse to assemle, align front end and wholla! your done. 1 hour,15 min. $115.00 to do it yourself.
SOURCE: replacing cv joint for 1998 olds bravada
if you need parts here is a place that sells on GM parts Schram auto and truck parts 1-800-292-1032 for used parts try junkyarddog.com for diagrams try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you
the axle seal yes. the drive bearing? are you talking the one inside the trans or the cv joints or the outer wheel bearing the bearings inside the tranny cannot be replaced without pulling the trans out.the others can be.
SOURCE: On my oldsmobile aurora, I have a problem turning
More than likely your rack and pinion has gone bad. If the pump was bad it wouldn't work to either side. But the rack and pinion can go bad on just one side
Testimonial: "How difficult is it to replace it? Would I need to replace both sides or just one? And it sounds as if it whines somewhere on the left side up by the tire. What would that be?"
37 views
Usually answered in minutes!
×