SOURCE: knock sensor for 1997 chevy C1500 Pickup Truck
Located on right hand side of block (pass side). It is between motor mount and starter.
SOURCE: nned steerin column diagram
I don't have a diagram, But I have taken tons of these apart. Is there something I can help with?
SOURCE: Wiring 7 pin trailer plug for 1998 C1500 pickup truck Z71
Here is some information that I find useful when wiring trailer connectors, and the brake controller should be wired into the vehicles wiring according to the instructions that came with the brake controller and that identifies each wire from the brake controller.
Be sure that you solder all connections well for the best operation, and you should use 10 or 12 ga. wire for the Pos. (+) connection, and the ground or Neg. (-) connection, and you should run both wires all the way out to the battery, and about one foot from the battery on the Pos. (+) wire to the battery, make sure that you use a 20 or 30 amp Circuit Breaker and Do Not Use A Fuse.
The rest of these diagrams should help you to get your trailer properly wired up.
SOURCE: 1998 Chevrolet C1500 Speed Sensor
Hello, the steering position sensor just snaps into the bottom of the steering column. remove the steering shaft at the bottom of steering column, then slide the sensor off
SOURCE: Code p0141 02 Sensor Heater Circuit Malfunct Bank #1 Sensor2
after the catalytic converter on the driver side in the exhaust pipe.
Testimonial: "Awesome info. Thanks!"
176 views
Usually answered in minutes!
×