Fuselink wire from battery to altenator burnt i spliced in a 60amp inline fuse keeps blowing fuse
SOURCE: battery removal
The battery is located under the right front fender behind the tire. Remove the wheel, remove access panel from fender well. From engine compartment, remove 2 battery hold down bolts,10mm, slide battery rearward to remove battery cables.
SOURCE: 2000 chrysler concorde switch unlocks but wont lock doors.
sounds like the actuator. I had the same problem. Mine got to the point where it will now only work with the key. Had it looked at by dealer.. actuator is bad. Good luck.
SOURCE: chrysler wont start
Sounds like a short maybe. maybe the wire completely broke? if you know a technician, see if the fuel pump is even getting power when key is on
SOURCE: HOW DO I CHANGE THE BATTERY IN MY 2001 CHRYSLER CONCORDE?
You will need to disengage the Negative terminal (Black side) and then the Red (positive side). In addition, there might be a securing bracket with two bolts or wing nuts, loosen these and the rods can be pushed down and twist out of the bottom. Once this is done remove the battery and head to your local Auto parts store, they can help you select the correct one. re-assemble as you have taken apart. you will need to re program your stereo and reset your clock, (prior to removing terminals) make sure there are no special lock out codes for your stereo. Good luck!
158 views
Usually answered in minutes!
×